Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 0   File size: 3 mb   Manafacture: Sears  
Category: Snow Blowers
@name

= 11 11 11 ,=H ,,,,HH= ,H 111 11,11,1 =,==,=H= 11 1111 SAFETY RULES _ CAUTION. ALWAYS DISCONNECT SPARK PLUG WIRE ANDPLACE WIRE WHERE IT CANNOT CONTACT SPARK PLUG TQ PREVENT ACCIDENTAL STARTING WHEN SETTING-UP, _li TRANSPORTING, ADJUSTING OR MAKING REPAIRS, IMPORTANT SAFETY STANDARDS REQUIRE OPERATOR PRESENCE CONTROLS TO MINIMIZE THE RISK OF INJURY. YOUR SNOW THROWER IS EQUIPPED WITH SUCH CONTROLS. DO NOT ATTEMPT TO DEFEAT THE FUNCTION OF THE OPERATOR PRESENCE CONTROL UNDER ANY CIRCUMSTANCES. TRA

downloaded: 8   File size: 4 mb   Manafacture: Sears  
Category: Snow Blowers
@name

inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 45 BRIGGS & STRATTON 4-CYCLE ENGINE MODEL NUMBER 20M314-1370=E2 KEY PART KEY PART NO. NO. DESCRIPTION NO. NO. DESCRIPTION 528 793006 Hose-Primer 957 795027 Cap-Fuel 529 791822 Grommet 972 694260 Tank-Fuel 552 694674 Bushing-Governor Crank 975 698783 Bowl-Float 562 793216 Bolt (Governor Control Lever) 976 793

downloaded: 0   File size: 4 mb   Manafacture: Sears  
Category: Snow Blowers
@name

Failure to observe the following safety instructions could result in serious injury. & & Look for this symbol to point out ira= portant safety precautions. It means CAUTION!!! BECOMEALERT!!! YOUR SAFETY IS INVOLVED. & & WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in order to prevent acci= dental starting when setting up, trans porting, adjusting or making repairs. WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surface

downloaded: 0   File size: 2 mb   Manafacture: Sears  
Category: Snow Blowers
@name

HAZARD TO OPERATOR, BYSTANDERS, PROPERTYOR UNIT MAY Look for this symbol, It means --ATTENTION! BECOME ALERT! A EXIST, Page Page OWNERS INFORMATION ........................... 2 impeller/Auger Control Cable Adjustment ......... 10 MAINTENANCE AGREEMENT ....... :. .............. 2 Carburetor Adjustment .......................... 10 "WARRANTY ....................................... 2 Spark Plug Adjustment .......................... 10 OPERATIONAL PRECAUTIONS ...................... 3 MAINTENANCE ..

downloaded: 8   File size: 1 mb   Manafacture: Sears  
Category: Snow Blowers
@name

ELECTRIC START SNOW THROWER WHEN ORDERING REPAIR PARTS, ALWAYS Each SNOW THROWER has its own MODEL NUMBER found on the engine mount frame. Each ENGINE has its own MODEL NUMBER found on the BLOWER HOUSING. Always mention these MODEL NUMBERS when requesting service or Repair Parts for your SNOW THROWER. All parts may be orderedthrough Sears, Roebuck and Company Service Centers and most Retail Stores, GIVE THE FOLLOWING INFORMATION: * PRODUCT -"SNOW THROWER" * MODEL NUMBER -536.886331 * ENGINE MODE

downloaded: 1   File size: 4 mb   Manafacture: Sears  
Category: Snow Blowers
@name

e Position the snow thrower so the oil drain plug isthe lowest point on the engine_ Remove the oil drain plug and oil fill cap/dipstick, Drain the oil into a suitable container. The oil will drain more freely when warm. Replace the oit drain plug and tighten securely_ Refill the crankcase with SA.E_ 10W-30 motor oi! (or equivalent)., S,A.E. 5W-30 motor oil may be used to make starting easier in areas where the temperature is consistently 20° F. or lower, SPARK PLUG o Make su re the spark plug is

downloaded: 0   File size: 4 mb   Manafacture: Sears  
Category: Snow Blowers
@name

® Cut allfourcomersof the cartonfromtop to bottom and lay laythe panelsflat,. e Removethe packingmaterialfrom the shifterplate and upperhandleassembly. e Rollthesnowlhmweroffthecartonby pullingonthe lower handle,, NOTE: Thedrive systemmay betightwhenyoufirstuse yoursnowthrower.It loosensup as youuse ito e To completeupper handle installationand install chutecrankassembly,see To InstallThe UpperHandle and CrankAssemblyparagraphon page8. NOTE: Ifthecableshave becomedisconnectedfromthe clutchlevers

downloaded: 21   File size: 4 mb   Manafacture: Sears  
Category: Snow Blowers
@name

• Remove the belt cover (See Fig 26) • Engage the auger drive clutch lever, • Measure the distance between the belt guides and the belt (See Fig 28)° The distance should be 3/32" for each guide. • If adjustment is necessary, loosen the belt guide mounting bolts. Move the belt guides to the correct position Tighten the mounting bolts o Reinstall the belt cover. o Reconnect the spark plug wire REM -_BI_.__I |_.BOLT LOOSEN BOLT,.._ LOOSEN BOLT PANEL TRACK CONNECTING ROD ,,,, H i m, Jll,J ..... TO A

downloaded: 3   File size: 4 mb   Manafacture: Sears  
Category: Snow Blowers
@name

• Safety • Assembly • Operation • Maintenance • Parts PRINTED IN U.S.A. FORM NO. 49788 (REV. 7/05) Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. IMPORTANT - READ THIS FIRST!!! For Missing Parts or Assembly Questions Please Call 866-576-8388 Mon.-Fri. 7 am - 5 pm CST. FAX 217-728-2032 or e-mail info@agri-fab.com Missing parts will be sent UPS in 24 hours di rect ly to your home. ® TABLE OF CONTENTS ACCESSORIES...........................................................2 SAFETY RULES....

downloaded: 0   File size: 1 mb   Manafacture: Sears  
Category: Snow Blowers
@name

60179 U.S.A. PRINTED IN U.S.A. RULES FOR SAFE OPERATIONS Any power equipment can cause injury if operated improperly or if the user does not understand how to operate the equipment. LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS, IT MEANS --ATTENTION! BECOME ALERTJ YOUR SAFETY IS INVOLVED, Exercise caution at all times, when using power equipment. 1. Read the tractor and snow blade owners manuals and know how to operate your tractor before using tractor with snow blade attachment





Category