Votes - 3, Average rating: 4
(
)
)
|
manual abstract
The FAB-1100 is installed in the GI-3821 in accordance with instructions provided with that appliance. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Factory Supplied Not Supplied with Blower Kit Blower Plug Junction Box ON/OFF Wall Switch 120Vac 60Hz} Factory Supplied Not Supplied with Blower Kit Blower Plug Junction Box ON/OFF Wall Switch 120Vac 60Hz} APPLIANCE WIRING Most appliances are fitted with an electrical "J" box that can be accessed from outside of the appliance outer wrapper at the time of installation. The following general instructions apply. WARNING: DO NOT CONFUSE BLOWER 120 VAC 60HZ WIRING CIRCUIT WITH THE APPLIANCE LOW VOLTAGE (MILLIVOLT) OPERATING CIRCUIT. CAUTION: ELECTRICAL CONNECTIONS SHOULD ONLY BE PERFORMED BY A QUALIFIED, LICENSED ELECTRICIAN. MAIN POWER SUPPLY MUST BE TURNED OFF BEFORE CONNECTING FANS TO MAIN ELECTRICAL POWER SUPPLY OR PERFORMING SERVICE. Step 1. Remove the external "J" box cover by removing the hex-head screw. The receptacle should be wired into an electrical circuit during the framing of the appliance. The “J” box cover has a 7/8" (22mm) diameter knockout hole for connection of a conduit bushing. Step 2. Wire with minimum 600 C wire in accordance with prevailing codes. The blower draws 1 amp at 120 Vac 60Hz. CAUTION: MAIN POWER SUPPLY MUST BE TURNED OFF BEFORE EXTERNAL WIRING IS PERFORMED. Step 3. Connect the ground wire to the ground screw located on the inside of the “J” box or on the “J” box plate. Step 4. Replace the “J” box cover back onto the side access opening and secure with the hex head screw. Step 5. Connect the wall switch (not provided with blower kit) to the supply wires in the wall receptacle box (Figure 4). Figure 4 Switch Plate Wall Box Switch Black BlackNeutralWhiteSupply To Blower NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. LHP Printed in U.S.A. © 1996 by Lennox Hearth Products 1110 West Taft Avenue P/N 903249 REV. E 11/2004 Orange, CA 92865 ...
Other models in this manual:Blower systems - FAB-1100 (53.07 kb)