Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 2   File size: 0 kb   Manafacture: DeWalt  
Category: Sanders

downloaded: 0   File size: 0 kb   Manafacture: DeWalt  
Category: Sanders

downloaded: 0   File size: 0 kb   Manafacture: DeWalt  
Category: Sanders

downloaded: 1   File size: 0 kb   Manafacture: DeWalt  
Category: Sanders

downloaded: 4   File size: 0 kb   Manafacture: DeWalt  
Category: Sanders

downloaded: 0   File size: 137 kb   Manafacture: DeWalt  
Category: Sanders
@name@name@name

3. Screw the threaded clamp nut onto the spindle (D). 4. Rotate the spindle by hand while pressing the spindle lock fully until it has found its locking location and holds the spindle still (E). 5. Firmly tighten the threaded flange with the supplied hex wrench (F). Mounting Edge Cutting Wheels (Fig. 2) Type 27 Edge cutting wheels are available as optional accessories. Before fitting a cutting wheel, unplug tool from the power source. 1. Locate the inner clamp nut (A) on the machine spindle (B).

downloaded: 2   File size: 2 mb   Manafacture: DeWalt  
Category: Sanders
@name@name@name

Allow the tool to stop rotating before laying it down. WARNING: Do not use edge grinding/cutting wheels for surface grinding applications because these wheels are not designed for side pressures encountered with surface grinding. Wheel breakage and injury may result. 9 SURFACE FINISHING WITH SANDING FLAP DISCS 1. Allow the tool to reach full speed before touching work surface. 2. Apply minimum pressure to work surface, allowing operate at high speed. Sanding rate is greatest when operates at hig

downloaded: 4   File size: 2 mb   Manafacture: DeWalt  
Category: Sanders
@name@name@name

Allow the grinder to run up to full speed before touching the work surface. Lift the tool from the surface before turning the tool off. Allow the tool to stop rotating before putting it down. PADDLE SWITCH (D28402, D28402N) CAUTION: Before connecting the tool to a power source depress and release the paddle switch (A) once [D28402: without depressing the lock-on button (J)] to ensure that the switch is off. Depress and release the paddle switch as described above after any interruption in power

downloaded: 6   File size: 2 mb   Manafacture: DeWalt  
Category: Sanders
@name@name@name

English English 4-1/2" Cutting Wheels Sanding Discs 4-1/2" Sanding Flap Discs Type 1 guard backing flange abrasive cutting wheel clamp nut Type 1 guard backing flange diamond cutting wheel clamp nut rubber backing pad sanding disc threaded clamp nut hubbed sanding flap disc backing flange non-hubbed sanding flap disc threaded clamp nut Type 27 guard Type 27 guard 1. Open the guard latch (M). Align N the lugs (N) on the guard with the slots (O) on the gear case. 2. Push the guard down until the g

downloaded: 4   File size: 0 kb   Manafacture: DeWalt  
Category: Sanders





Category