Votes - 5, Average rating: 3.6 ( )

Manafacture: AMX File size: 107.08 kb File name: DAS-AMP.InstallationGuide.pdf Language of manual:

FIG. 1 DAS-AMP4/8 amplifiers •The DAS-AMP4 is a 4-channel amp that provides 2 speaker pairs per unit. •The DAS-AMP8 is an 8-channel amp that supports an additional 4 speaker pairs per unit. Features • High-quality sound - delivers 60 watts of high-quality sound per channel. • Expandable - stack up to three Carbon XA amplifiers units per zone to allow up to 12 speaker pairs (24 channels) in a single zone. • Easy installation - SWT (Speaker Wire Technology) makes installation simple using four-conductor speaker wire. • Integrates with Delta Series and Mi Series controllers, as well as C, C-DT and EL Series speakers. Product Specifications Carbon XA Amplifiers Product Specifications Models Available: DAS-AMP4 4-Channel amplifier • US version (120V) - FG1102-01 • Int’l version (230V) - FG1102-03 DAS-AMP8 8-Channel amplifier • US version (120V) - FG1102-02 • Int’l version (230V) - FG1102-04 Dimensions (HWD): • 3 1/16” x 17” x 13 1/2” (7.68cm x 43.18cm x 33.52cm) •RU: 2 Weight: 25.75 lbs (11.68 kg) Power: • High current Torroidal power supply • Maximum: 634 W Average usage: • DAS-AMP4: 250 W • DAS-AMP8: 500 W Stereo Output: • Dual mono amplifier stage design • 60 W per channel (1 KHz continuous .006%@ 8 Ohms THD+N) • Each Carbon XA amplifier is capable of providing 480 watts @ 8 Ohms Configuration: • Modular Design - configurable in single pairs up to 4 stereo pairs (8 channels). • Stackable (up to 3 Carbon XA amplifiers) Control Options: • Matrix keypad • C-Series speakers using SWT Front Panel Components: Dual stage status LED: • Red in standby • Green when active Rear Panel Components: Power Switch & Receptacle The master power switch will remain in the ON position normally. Output 1-4: SWT connectors provide direct connection to speakers. From Controller: SWT input port (connects to Audio Controller) Carbon XA Amplifiers - Product Specifications (Cont.) To Keypad: SWT output port (connects to Matrix keypad or interface) This connector can also be used to connect to a another Carbon XA amplifier, to allow for expansion (up to three Carbon XA amplifiers units per zone). Included Accessories: Power Cord Other AMX Equipment: DAS-MRMK Mi Series Rack Mount Kit (FG1101-60) Wiring and Connections Front and Rear Panel Components FIG. 2 provides views of the front and rear panels of the DAS-AMP4/8 Carbon XA amplifiers. Note that the front panel is identical for both Carbon XA Amps, and the only difference between the two relative to the rear panel is the number of Zone Outputs (2 on the DAS-AMP4, or 4 on the DAS-AMP8). Status LED FIG. 2 Carbon XA amplifiers (DAS-AMP8 shown) To Keypad From Controller Zone Outputs (2 or 4) Power Switch & Receptacle Cabling Instructions This installation uses low voltage cabling similar to telephone and alarm wiring, and as such does not commonly have very many restrictions on their installation. However rules may vary in different regions. Note: Be sure to check for any wiring restrictions required by the electrical code in yo...

Download now

Please, enter two numbers from picture: