Votes - 1, Average rating: 5 ( )

Manafacture: AMX File size: 107.08 kb File name: Language of manual:

3 SWT pinout configuration Connecting SWT Speakers Wiring Diagram - Expanded Configuration Matrix Audio SWT Speakers are different from any other speaker available on the market. They allow you to control a single zone of audio without a keypad being installed. Therefore, some different wiring practices must be considered for proper operation and control. This is achieved by “daisy-chaining” from the first speaker to the second speaker. The main run of 16/4 from the controller will go directly to the first speaker in the zone. • At the controller end, the wiring is left-to-right: L D G R. • At the speaker end, refer to the labeling on speaker PCB to ensure the correct wiring. The labelling at both ends must match or the IR control will not work (i.e.: if you used the RED wire for the Left Audio labelled “L” at the zone output, you must use the RED wire for the pin labelled “L” on the speaker connector). Note: Be sure to screw the connector down to the speaker crossover board before installing and securing in the ceiling. This will ensure that the connector will not disconnect after installation. A single run of 16/2 must be run from the first speaker to the second speaker. Connecting Non-SWT Speakers Each speaker has a Red (positive) terminal and a Black (negative) terminal. Connect the appropriate wire from the keypad to Red and Black terminals on the Left and Right speakers, as with any standard speaker installation. Connecting To a Mi-Series Audio Controller Connect the amplifier to the Audio Controller via the 4-pin connector labelled From Controller on the rear panel of the amplifier (see FIG. 4). Connecting SWT Keypads Connect SWT Keypads (DAS-MET-6SRC or K-Series) to the amplifier via the SWT connector labelled To Keypad on the rear panel of the amplifier (see FIG. 4). Note: When stripping cable for use with SWT connector, only strip away about .” (6mm) of the insulation from each wire. The complete assembly should not have more than 1/32” (1mm) of bare wire exposed from the bottom of the connector. Wiring Diagram - Single Amplifier FIG. 4 illustrates the connections from a Mi-Series Audio Controller, and to SWT Speakers and Matrix (SWT) Keypad. Mi-Series Audio Controller Carbon XA Amplifier DAS-KP-LCD-G LCD Keypad FIG. 4 Single Amp FIG. 5 illustrates stacking up to three Carbon XA amplifiers units per zone, to allow up to 12 speaker pairs (24 channels) in a single zone: Note: Only one Keypad is allowed per zone. Carbon XA Amplifier #1 Carbon XA Amplifier #2 Carbon XA Amplifier #3 DAS-KP-LCD-G LCD Keypad Mi-Series Audio Controller FIG. 5 Expanded Configuration (showing three DAS-AMP8 8-Channel Amps) To "stack" Carbon XA amplifiers, connect the To Keypad connector on the first amplifier to the From Controller connector on the second amplifier. To add a third Amp to the configuration, connect the To Keypad connector on the second Amp to the From Controller connector on the third Amp. The Matrix Keypad can be connected serially between the Au...

Download now

Please, enter two numbers from picture: