Votes - 3, Average rating: 4
(
)
)
|
manual abstract
Install in accordance with the manufacturers instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments/accessories specified by the manufacturer. 12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storm or when unused for long periods of time. 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been I JJeA I exposed to rain or moisture, does not VSy operate normally, or has been dropped. 15. The AC/DC adaptor and apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on apparatus. WARNING: To reduce the risk of electric shock, do not expose this apparatus to rain or moisture. • Marking plate was located at bottom enclosure of the apparatus. A A CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. 1 A The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. A The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. FCC NOTES This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technical for help. OPERATING INSTRUCTIONS 1. SNOOZE/SLEEP OFF BUTTON 2. SLEEP SET BUTTON 3. MINUTE SET BUTTON 4 HOUR SET BUTTON 5. TUNING CONTROL 6. ALARM SET BUTTON 7. ON/OFF/AUTO/ALARM SELECTOR 2 AM/FM ALARM CLOCK RADIO 8. TIME SET BUTTON 9. VOLUME CONTROL 10. FM ANTENNA (FOR EXTERNAL ANTENNA) 11. AUTO INDICATOR 12. MAIN PLUG (AC CORD) 13. ALARM OFF BUTTON 14. AM/FM SELECTOR AC POWER OPERATION Before connecting to the power supply ensure that the supply corresponds to the information on the rating label on the bottom of the apparatus WARNING Disconnect the mains plug from the supply socket when not in use. To prevent fire of shock hazard do not expose the apparatus to rain or moisture. SETTING THE CLOCK 1. Set the On/Off/Auto/Alarm Switch (7) to “OFF". Connect the Main Lead to the power supply. The clock display will flash on and off indicating a power interruption and that the display time is incorrect. 2. To set the correct time, press the Time Set Button(3) ...