Login:
Votes - 2, Average rating: 4 ( )

User manual Dometic, model 9093200-(X)PR

Manafacture: Dometic
File size: 433.43 kb
File name: 2c9442cf-4256-40a3-96b9-b5c88803816b.pdf
Language of manual:en
Free link for this manual available at the bottom of the page



manual abstract


When the secondary filter becomes dirty, rinse in warm water or replace with a new filter. Filters shall be completely dry before using. 8. Never drop or insert any object into any opening. 9. Turn off all controls before unplugging. 10. Do not pull or carry by the power cord, do not use power cord as a handle, do not close a door on the power cord, or pull power cord around sharp edges or corners. Do not run appliance over power cord. Keep power cord away from heated surfaces. 11. Do not unplug by pulling on power cord. To unplug, grasp the plug not the power cord. 12. Keep hair, loose clothing, fingers, and all parts of body away from any opening and moving parts. 13. Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. 14. Use extra caution when cleaning on stairs. 15. Do not handle plug or appliance with wet hands. 16. Do not pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present. 17. Do not place objects against the vacuum cleaner. Keep area clear. 18. Do not step on the hose or pull the hose forcibly. 19. Do not pick up large objects such as waste paper or cloth, which may clog the hose. 20. Do not install this vacuum cleaner in an area exposed to high temperatures. 21. Install this vacuum cleaner in a dry place. 22. Do not attempt to service the vacuum cleaner. Unit is sealed and cannot be opened without damage to the unit. For service, call your local authorized service dealer, or Dometic. 5 CENTRAL RV VACUUM FIG. 4 DOOR LATCH INLET VALVE COVER UNIT CAN BE MOUNTED ON SIDE OR BACK VACUUM HOSE MODEL LABEL INSIDE DUST BAG FRONT PANEL SWITCH B. A few minutes of operating of the vacuum cleaner will result in the discharge of warm exhaust air. This is normal operation; however, a full dust bag or a dirty motor filter can cause the motor to stop. If this occurs see step H. Troubleshooting, points a - e. WARNING! To reduce the risk of fire, injury or damage: Do not pick up lit cigarettes, hot ashes, razor blades, needles, pins or other sharp objects. C. CONNECTING AND DISCONNECTING HOSE 1. Lift up the inlet valve cover on the front door panel. 2. Insert hose with a slight twist motion in either direction. Removal of hose is done with a twist motion in either direction, while pulling outward. See FIG. 4. D. STARTING AND STOPPING VACUUM CLEANER 1. Start the vacuum by pushing the switch to the “ON” position. See FIG. 4. 2. Stop the vacuum cleaner by pushing the switch to the “OFF” position. See FIG. 4. E. CHANGING DUST BAG 1. Remove the vacuum cleaner door by pushing the latch up. See FIG. 4. 2. Push the new bag onto the door’s scoop shaped pipe as far as possible. See FIG. 5. 3. Slide bottom of bag into vacuum cleaner cavity, then place bottom of door in the front panel slots. 4. Tuck in the left and right corners of the bag so the door can close. Close the door, then push down on latch when it is in place the door is sealed and the vacuum cleaner is ready for use. See FIG. 4. 5. When removing a full bag reverse the installation procedure. Note: Accidental spilling of the contents of the dust bag can be prevented by leaving it attached to the door. Carry both door and dirt bag to the trash, where the dirt bag can be removed. Note: Part number for the dust bag is 3308150.006, a package of 3 dust bag is 3308169.006 and the 10 count package is 3308165.004 {a package of 10 dust bags contains (2) 3308172.000 motor filters and (1) 3308170.004 exhaust filter}. Every fifth change of bag replace motor filter, or when the white part of filter is very dirty. Filter can be hand washed. Contact your nearest Dometic Dealer for replacements. FIG. 5 PUSH DUST BAG ON DUST BAGDOOR SCOOP AS FAR AS POSSIBLE 6 CENTRAL RV VACUUM F. CHANGING MOTOR FILTER H. TROUBLESHOOTING 1. Remove completely the door with the dust bag. 2. Remove the motor filter from the bottom of the vacuum cleaner cavity. See FIG. 6. 3. Install the new motor filter with dark side up. Tuck in the corners so that the filter lays flat on the grid in the cavity. Note: Clean the dirty motor filter by washing in mild soap by hand. Do not machine wash. Let filter air dry before replacing. See note in Step D Changing Dust Bag. FIG. 6 MOTOR FILTER WITH DARK SIDE UP FRONT PANEL FILTER MUST LAY FLAT ON GRILL TUCK CORNERS IN G. CHANGING EXHAUST FILTER 1. The exhaust filter is located in the opening at the bottom of the vacuum cleaner front panel. 2. Push the plastic pins on the gate upward, then pull the gate frame forward and down. See. FIG. 7. 3. Turn the switch to “ON” to start the vacuum cleaner. The exhaust of the vacuum cleaner should blow the exhaust filter out the opening. Turn the vacuum cleaner “OFF”. See FIG. 4. 1. If your motor stops check the following: a. Vacuuming large amounts of dust other than household dirt, (drywall dust, fine wood dust, etc.) can block the pores of the dust bag rapidly even if the dust bag is new. b. The vacuum hose could be clogged. c. The vacuum to...

Other models in this manual:
Vacuum Cleaners - 9093100-(X)PR (433.43 kb)

Reviews



Your review
Your name:
Please, enter two numbers from picture:
capcha





Category