Do’s and Don’ts 01. Open the bezel door. 02. Press the release button. Pull the locking lever and remove the HDD tray. 03. 04. Slide hard disk into blank. Secure the hard drive to the tray with 4 screws as shown. Do not over tighten the screws. Slide the blank into the bay until it locks into place. 05. 06. Press power button to boot up. Power & NetworkConnections or Cable port on the wall Cable / ADSL / VDSL modem IP Router PC or Notebook Power cable Internet Please refer to the following figur

Companies, names, and data used in examples herein are fictitious unless otherwise noted. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of Kloudian Systems Inc. Orbweb is copyright of Kloudian Systems Inc. All rights reserved. Version 2.1.2.2 – Last updated 2011/08/27 .Kloudian Systems Inc. All rights reserved. Tabl e of Contents System Requirements Chapter 1. General Setup

Companies, names, and data used in examples herein are fictitious unless otherwise noted. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of Kloudian Systems Inc. Orbweb is copyright of Kloudian Systems Inc. All rights reserved. Version 2.1.2.2 – Last updated 2011/08/27 .Kloudian Systems Inc. All rights reserved. Tabl e of Contents System Requirements Chapter 1. General Setup