Votes - 1, Average rating: 4 ( )

Manafacture: AeroGarden File size: 924.55 kb File name: Language of manual:

Rinse and clean Grow Surface, Pump Stand and Pump Filter*. • Use a soft scrub brush to clean tangled roots from underside of Grow Surface and Pump Stand. • Remove Pump Filter from Pump Stand. Gently scrub roots from Pump Filter. • Place Pump Filter back into Pump Stand. After cleaning, there may still be a few roots in your Grow Surface, Pump Stand or Pump Filter. This will not affect the operation of your AeroGarden. 1 2 3 4 5 6 9 7 8 10 11 * IMPORTANT NOTE: We recommend replacing the Pump Filter after growing two gardens. Order Pump Filters from or from your retailer. Pump Stand Pump Filter Plant Growth Seed Pod Roots Grow Surface Grow Surface Bowl Base Lamp Hood cleaning and Storage Instructions for your AeroGarden When your garden has completed its growing cycle… Prepare For Your Next Garden (continued) Prepare For Your Next Garden (continued) ! Bundle cord when furnishing is not in use. Before planting a new garden, be sure to restart the nutrient timer. • Press and hold “Reset” button until the red “Add Nutrient” light blinks 3 or 4 times (approximately 9 seconds). • Release “Reset” button. “Add Nutrient” light will turn off. • Your nutrient timer is now reset. (In some cases you may see other lights blink as well. This is nothing to worry about.) Remember to... • Replace your Grow Bulbs after 6 months of use. Grow Bulbs can be ordered at or from your retailer. • Sanitize your AeroGarden before re-planting (see page 12). • Set Lamp Hood to the lowest position when starting a new garden. If you have already grown a garden in your AeroGarden, please follow the instructions below to reset the nutrient timer: If this is the FIRST garden planted in your AeroGarden, you may DISREGARD these instructions. Replanting Your AeroGarden Add Nutrient Reset notes… U.S. CAUTION – You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. noTe: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; ...

Download now

Please, enter two numbers from picture: