Votes - 4, Average rating: 3.5
(
)
)
|
manual abstract
Unpack the machine and its components. Check that you have the following: . Machine . Cartridge . Power cord . USB cable . User Software CD (MF Setup,NewSoft Presto! PageManager, ScanSoft Omnipage SE, Software Guide) . Documentation (Set-Up Instructions, Basic Guide, Registration Card, Limited Warranty Note, Limited Warranty Note for Cartridge X25) Before setting up the machine: 1 Place the machine on a flat, stable surface. 2 Remove all shipping tapes from the exterior of the machine. . Cassette extension . Extension cover . Output tray Install the cartridge. 4 Pull open the front cover. 1 Remove the cartridge from the bag. Keep the bag in a safe place for future use. 2 Gently rock the cartridge several times to evenly distribute the toner inside. 3 Hold the cartridge on a flat stable surface with one hand, and break the tab . and pull out the seal . completely with the other hand. B A 5 Hold the cartridge so that the instructions (A) and the arrow (B) are facing up, and insert it in the machine horizontally as far as it will go. 6 Close the front cover of the machine. Assemble the cassette and load paper. 3 Attach the extension to the cassette.The slots . are keyed and must be inserted at a 90° angle. Once inserted, fold the extension as shown .. To load Legal-size paper: Pull the blue tab . and extend the cassette . as far as it will go. Keep the rear paper end guide to LTR size mark. If you are not using Legal-size paper, skip to the next step without extending the cassette. 1 Insert the output tray into the front slot on the machine. 2 Pull out the paper cassette. 4 Pinch and slide the rear paper end guide to match the size of paper. 7 Even out the edges of the paper stack. Make sure the height of the stack does not exceed the limit marks and that the side edges of the stack are below the hooks (B). 9 Insert the tabs on the extension cover into the slots . on the back of the machine, and carefully lower the cover . until it sits on the cassette extension beneath it. 5 Load the paper into the cassette.Make sure the paper stack sits below the hooks (A). 6 Pinch and slide the side paper end guides to match the size of paper. A B 8 Insert the paper cassette back into the machine as far as it will go. NOTE . If you do not completely insert the cassette into the machine, paper jams may occur. IMPORTANT . Do not load paper from the back of the machine.Doing so may damage the paper feeding assembly inside the machine. Connect the power cord. 1 Plug the power cord into the rear socket ..Then connect the other end to the wall outlet .. 2 The machine takes up to 3 minutes to warm up. Once it is warmed up, the standby display appears in the LCD. IMPORTANT . For important safety instructions on installation and handling of the machine, see “Important Safety Instructions” in the Basic Guide. NOTE . Make sure the correct paper size is specified in the machine.For details,see Chapter 2,“Paper Handling,”in the Basic Guide. Install the software. IMPORTANT . Do not connect the USB cable before installing the software. If you connect the USB cable before installing the software and the Found New Hardware Wizard screen appears, c...