Votes - 3, Average rating: 3.7 ( )

Manafacture: Epson File size: 314.82 kb File name: Language of manual:

Please contact local distributor if still have problem. Pic.3-10-1 Pic. 3-10-2, 3-10-3 IV. Notice It requires to change cartridges while printing (4-1-1) and ink light flash (4-1-2). Press ink button to move out cartridge holder. Press chip reset button for 3 seconds (4- 1-3), repress ink button to move back cartridge holder, then ink amount shows 99% again. Redo nozzle inspection and printer can run normally if it is alright. (Black and other colors can be handled by the same method). Note: Distinguish two kinds of chips (4-1-4). The manipulation is the same. The difference is that the chips with transferred switch should be switched downwards (4-1- 5), otherwise, chips can not be recognized. Pic. 4-1-1 Pic. 4-1-2 Pic. 4-1-3 Pic. 4-1-4 Pic. 4-1-5 V. Removing used continuous ink supply system Replace air filters with air plugs (5-1-1).Move out cartridge holder and take the rack off. Take the cartridges out (5-1-2) and place the cartridges on the tissue with the ink flow nozzle downwards, and let the tissue at the same level with the system ink tank (5-1-3). Pic. 5-1-1 Pic. 5-1-2 Pic. 5-1-3 VI. Refill ink During printing, if you found out that the ink level in the tank is below the red line, please add ink according to the methods. VII. Check air balance tube During printing, if you find some abnormal cases, such as bad output, ink drip out on paper, then you need to check the air balance tube to see if exist ink. If yes, please do according to the manual of "ink pump out from balance tube”. VIII. Warnings 1. During printing, please do not take cartridges over than the printer. Please keep ink tank and printer in the same level. 2. During printing, do not inverse, lift up or lower ink tanks. 3. Please do not block up ink tanks for curiosity or for fear of less ink 4. Use CISS at clean environment and within the temperature range 15-35 degrees. IX. Product Warranty INKSYSTEM warrants its products to be free from defects in material or workmanship. Rarely the equipment partly or completely fails within the warranty period. In these cases we do everything possible to ensure that our customers are satisfied with the purchase. The INKSYSTEM CISS installation is free in any of the representative offices. Please adhere to the following points to receive a warranty service as soon as possible: When accepting the product check if the warranty certificate is filled in correctly. . Try to avoid mechanical damages when operating the product: chippings, dents, fractures, scratches, etc. . Demonstrate the failed device to the service center managers (the warranty repair or replacement can be provided only upon the failed product availability). We cannot provide a warranty repair under several conditions: . If the warranty certificate is wrongly filled in. . If the device has mechanical damages: chippings, dents, fractures, scratches, etc. . If the identification information was removed or the information identification has been complicated in any possible way: additional notes, stickers, etc. . If the user has previously performed a repair or change in the internal parts of the device. . If the equipment has previously been repaired in a service center that is not an «INKSYSTEM» representative center. . If the device was installed by the user. . If the defect appeared under the circumstances of insuperable forces, accidents, intended or careless actions of the user or a third party. . If the ink used was not manufactured by “INKSYSTEM” (South Korea) . If the printing limit was exceeded – more than 100 000 prints. The “INKSYSTEM” Company excludes for itself any liability for incidental, consequential, indirect, special, or punitive damages of any kind to people, pets or property if the stated damages have been affected because of rules and operational conditions / product installation disregard. The Company also excludes any liability for intentional or careless actions of the user or third parties, for loss of revenue or profits, loss of business, loss of information or date, or other financial loss arising out of or in connection with the sale, installation, maintenance, use, performance, failure, or interruption of the possibility of such damages. Warranty certificate (Product) Continuous ink supply system (Model Name) _____________________________________ (Serial №) _____________________________________ (Date of ...

Download now

Please, enter two numbers from picture: