) Button 7. TUNING/CD Skip/Search Button 8. REPEAT/MEMORY UP Button 9. FM Wire Antenna (Rear of Unit) 10. HOLD SET Button 11. CD Function Button 12. TUNER Function Button 13. MEMORY/CLOCK SET Button 14. CD Compartment 15. AC Power jack (Rear of Unit) 16. VOLUME Up Button 17. VOLUME Down Button 18. COLOR MODE Button 19. PRESET EQ Button 20. CD Door OPEN/CLOSE Button 21. TIMER/Sleep Button 22. Headphones Jack 5 MX4302.O/M.QXD 3/4/03 7:47 AM Page 6 LOCATION OF CONTROLS AND INDICATORS REMOTE 1 13 2

REPEAT/CLOCK Button 14. Remote Sensor 15. STOP (n)/TIME SET/POWER OFF Button 16. PLAY/PAUSE (®p)/POWER ON Button 17. Headphone Jack 6 LOCATION OF CONTROLS (CONTINUED) LOCATION OF CONTROLS (CONTINUED) REAR 1. Speaker Jacks 2. AC Cord 3. FM Wire Antenna 1. VOLUME + Button 2. RADIO AM/FM/POWER ON Button REMOTE 3. PLAY/PAUSE (®p)/ POWER ON Button 4. TIME - /TUNING/ SKIP/SEARCH o Button 5. VOLUME – Button 6. PROGRAM/MEMORY Button 7. STOP (n)/TIME SET/ POWER OFF Button 8. EQ/TIMER Button 9. SLEEP Butt

However, improper use can potentially result in electrical shock or fire hazard. In order not to defeat the safeguards incorporated into this unit, observe all the following basic rules for installation, use and servicing. 1. Your unit is fully electronic and does not any user-serviceable parts. Hence, DON’T REMOVE THE CABINET COVER OF THIS UNIT IN WHICH MAY EXPOSE YOU TO DANGEROUS VOLTAGES. Please refer all servicing to a qualified service technician. 2. After unpacking the unit, check it car

14. POWER LINES An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. 4 SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE 15. OVERLOADING Do not overload wa

Alkaline and Carbon-zinc) or old batteries with fresh ones. 4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.) 5 6 RADIO OPERATION Rotate the FUNCTION control to the RADIO position. 1 When you have finished listening, rotate the FUNCTION control to the TAPE/OFF positi

Insert one end of the AC line cord into the AC power jack on the rear of the unit and the other end (with the 2 blades) into a conveniently located AC outlet having 120V, 60Hz. When the AC cord is plugged in, the batteries will be disconnected. NOTE: The AC plug supplied with the unit is polarized to help minimize the possibility of electric shock. If the AC plug does not fit into a nonpolar AC PlugAC Outlet ized AC outlet, do not file or cut the wide blade. It is the user’s responsibility to ha

Insert a pre-recorded cassette into the slots in the cassette door with the open end facing up and the full reel on the right side. Close the cassette door. 3 4 Press the PLAY (A) button to begin playback. Adjust the VOLUME control 1 and BASS BOOST button 2 as desired. Press the BASS BOOST button 2 to the “in” position to enhance the bass sound. 5 6 To advance or rewind the tape rapidly, press either the F.FWD (AA) 1 or REWIND (®®) 2 button. When you reach the desired point, press the PLAY (A) b

Tune a desired station by turning the TUNING control. If an FM station is selected, and is broadcasting an FM stereo station, the FM STEREO indicator will light. Adjust the VOLUME . control and X-BASS . button as desired. Press the X-BASS button . to the in position to enhance the bass sound. To turn the radio off, slide the Function switch to the OFF position; the POWER indicator will go off. 4 ANTENNAS AM – This unit has a built-in ferrite rod antenna, which provides adequate reception in most

• Save these instructions for later use. • Follow all warnings and instructions marked on the audio equipment. 1. READ INSTRUCTIONS All the safety and operating instructions should be read before the product is operated. 2. RETAIN INSTRUCTIONS The safety and operating instructions should be retained for future reference. 3. HEED WARNINGS All warnings on the product and in the operating instructions should be adhered to. 4. FOLLOW INSTRUCTIONS All operating and use instructions should be followed

• To prevent damage to the disc, never open the CD door while the disc is rotating. Wait for the disc to stop before opening the CD door. Never touch the lens when the CD compartment door is open. • DO NOT use the carrying handle when playing a CD. The CD should only be used on a steady surface. 7 MP3112.OM.QXD 6/25/02 11:53 AM Page 8 COMPACT DISC (CD) OPERATION (CONTINUED) TO REPEATEDLY PLAY BACK ONE TRACK 1 31 2 2 1 23 Slide the Function switch to the CD position and insert a CD as described i