• Do not immerse spotlight in water. • Do not drop or throw spotlight. It contains glass and a sealed lead acid battery. • Only replace bulb with type indicated in specifications (12 volt, H3 75 watt quartz halogen). • Use only with AC or DC charging adapters that are provided with unit. Plug in the charging adapter at the spotlight first, then plug into the charging source. • Do not overcharge: – AC recharge up to 30 hours maximum. – DC recharge up to 4 hours maximum. • NEVER ATTEMPT TO USE THE

Do not expose the battery to water. Do not expose the battery to heat. Do not store in locations where the temperature may exceed 40°C. Charge only at ambient temperatures between 4°C and 40°C. Charge only using the chargers provided with the tool. When disposing of batteries, follow the instructions given in the section "Protecting the environment". 11 ENGLISH Chargers Your charger has been designed for a specific voltage. Always check that the mains voltage corresponds to the voltage on the ra

Inspection and repairs Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation. The following safety symbols are marked on your spotlight: Warning! To reduce the risk of injury, the user must read the instruction manual. Warning! Do not touch the lens as it becomes very hot during operation and remains hot for several minutes after the spotlight is switched off. Allow the spotlight to f

IN MOST CASES, A BLACK & DECKER REPRESENTATIVE CAN RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE A SUGGESTION OR COMMENT, GIVE US A CALL. YOUR FEEDBACK IS VITAL TO BLACK & DECKER. Catalog Number SL202B TO REDUCE THE RISK OF INJURY, THE USER MUST READ AND UNDERSTAND THE INSTRUCTION MANUAL SAVE THIS MANUAL FOR FUTURE REFERENCE. Cat. # SL202B Form # 90518422 May ’07 Copyright © 2007 Black & Decker Printed in China SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 1 GENERAL SAFETY WARNINGS AND INST

Inspection and repairs Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation. The following safety symbols are marked on your spotlight: Warning! To reduce the risk of injury, the user must read the instruction manual. Warning! Do not touch the lens as it becomes very hot during operation and remains hot for several minutes after the spotlight is switched off. Warning! Burn hazard. Ho

Make any needed repairs or replacement before using on the reel, 4, UNPLUG ANY TOOLS OR APPLIANCES CONNECTED TO THE CORD REEL BEFORE REELING. 5, Always plug the Cord Reel into an approved, grounded 120 volt receptacle. (Even if you plan to use only Double Insulated tools or appliances.) 8, Check the cord periodically for damage and have damaged cords replaced immediately. 7, Keep your Cord Reel out of the reach of children. 8, Store your Cord Reel in a cool, dry place out of direct sunlight

3. Loosen and remove six screws that secure spotlight housing. 4. Lift up and set aside the right side of the housing. 5. Remove wire spring and carefully pull out old bulb from the terminal. 6. Replace with a new H3 type, 12 volt, 100 watt bulb, available from an electrical supplyhouse or from Black & Decker (refer to the Service Information section). 7. Reverse the above procedure to re-assemble the spotlight. Note: When handling a new halogen bulb, do not touch the glass portion of the bulb.

Wa s hhands after handling. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK: • Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been dropped, or otherwise damaged in any way. • Do not open body casing. There are no user- s e rviceable parts inside; take it to a qualifieds e rvice technician when service or repair is required. Incorrect reassembly may result in arisk of electric shock or fire, and will void warranty. WARNING: FIRE HAZARD: Never contact combus

• DON’T OVERREACH. Keep proper footing and balance at all times. • DISCONNECT APPLIANCE. The AC Charger and DC Charging Adapter should be maintained in a readily operable condition. To avoid damage to the unit or Adapter, disconnect the unit from any power supply when not in use, before cleaning, during lightning storms, and changing accessories or when it will be unused for long periods of time. To disconnect the unit from the power supply, the AC Charger must be completely disconnected from an

Knowing how to properly use the cord reel will prevent you from having problems such as jams or uneven winding. © A. Lay the cord reel flat on the ground near an electrical outlet. The handle should be turned toward you. CAUTION When directed to do so, pull the cord simultaneously from both sides! Do not pull on the plug (male) end of the cord without pulling on the socket end. B. Simultaneously pull the cord from both sides of the cord reel until the plug will reach the outlet. If you do n