Votes - 1, Average rating: 4
(
)
)
|
manual abstract
Please observe the following when handling floppy disks: - Never touch the magnetic medium inside the disk. - Do not subject floppy disks to temperature extremes (eg., direct sunlight in an enclosed vehicle). Recommended temperature range: 10 to 50°C. - Do not expose floppy disks to strong magnetic fields, such as those generated by loudspeakers. • Floppy disks contain a 'write protect' tab which can protect the disk from accidental erasure. It is recommended that the tab be kept in the 'PROTECT' position and moved to the 'WRITE' position only when you wish to write new data onto the disk. • All important data should be copied onto backup disk(s). This provides a complete duplicate of the data should the original disk(s) be lost or damaged. • The identification label should be firmly fixed to the disk. Should the label come loose while the disk is in the drive, it may be difficult to remove the disk. • Put the disk back into its case for storage. 3 Part Names Front Panel Rear Panel See page 4 of the MT-1 20 Owner's Manual for these descriptions. The Output L jack 011 the MT-120S cannnot be used for Mono output. ■ Make sure that the Piano switch on the back of the MT-120S is set to “Int." V E3 7 AC Inlet Plug in the power cord that conies with the MT-120S, then plug the other end of the cord into a w; socket. Turning On the Power (1) Connect the AC cord that came with the unit into the MT-120S, then plug the other end into an AC socket. (2) Turn down the volume to its lowest level (all the way to the left). (3) Turn on the power switch. * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unil will operate normally. 4 Listen to a Song on Disk It's easy to listen to a song recorded on a disk: just insert the disk into the drive, select the Song you want to hear by pressing the Value buttons, and then press the Play button. Inserting the Disk (1) Insert the disk into the disk drive. This time around, we'll listen to one of the songs on the Demo Song Disk that came with your MT-1 20S. The title of the first song on the disk will appear in the display. Selecting a Song (2) By pressing the [Value -] and [Value +] buttons, the display will change to show the name of the next song on the disk. Value + In this example, we'll select the piano piece called "Minuet." Starting Play (3) Press the [Play] button to start playback of the song. The [Play] button will light. Adjust the volume using the MT-120S's volume slider. As you listen, you can read along with the music score at the end of the MT-120 Owner's Manual. Volume Stopping Playback (4) Press the [Stop] button to stop playback of the song. The [Play] button will go out. A "+" sign (just before the measure number in the display) indicates that play was stopped in the middle of that measure. 5 Tuning When you play the MT-120S (GS Sound Source) together with an acoustic instrument, make sure that the two are in tune with each other. MT-120S Tuning You can change the tuning using the Master Tune feature on the MT-120S as follows. * The factory default value for the Master Tune setting is 440.0Hz. (1) Press the [Disk/Tune] button two times. The display will show the frequency of the tuning note "A4". (2) Pressing [Play] causes an A4 (la) pitch to sound. Disk/Tune (3) While playing the middle A (la) on the piano (or the note of corresponding pitch on another instrument), use the [Value -] and [Value +] buttons to adjust the pitch (up or down). The sound stops when you press [Stop]. * This setting remains in memory even after the power is switched off. Value + Master Tune (4) Press [Enter] when everything is tuned to your satisfaction. The Play screen display will return. Enter 6 Playing Along with a Song on the Disk Using the Mute feature, you can turn off one part of a piano piece recorded on a disk and play that part yourself! Selecting a Song Try playing through a little of the "Minuet" (the printed music is included at the back of the MT-120's manual). ............— Value + (1) Insert the Demo disk into the disk drive, and by pressing the [Value -] and [Value +] buttons, select "Minuet." One Hand Practice This song has the left hand piano part recorded on Track 3, and the right hand part on Track 4. So, here's the plan: turn off Track 4 (the right hand part) and play it yourself on the piano! N /• When the green light above a track button is lit, the Song data recorded on that track will play. "Track (2) Press the [Count In] button, and the button's indicator will light. This lets you hear an audible two-measure count before the song starts playing. (3) Press the [Reset] button to reset the song to the beginning. (4) Press the Track 4 button so that the green light is turned off (mute). The right hand part will not be heard now. (5) Press the [Play] button, and the song "Minuet" will start to play; left hand part only...