Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
Push up the projection and slide the cover in the “OPEN” direction. When closing the cover, slide the cover in the “CLOSE” direction till the click under the plug cover projection rides over the engine cover. Finally, push in the projection. (2) Removing the spark plug Use an attached box wrench to remove or install the spark plug. (3) Checking the spark plug The clearance between two electrodes of spark plug (see the figure left) is 0.7 to 0.8 mm. Adjust to the correct clearance when it is too wide or too narrow. Clean thoroughly or replace the spark plug if it has accumulated carbon or contaminated. (4) Replacing the spark plug For replacement, use NGK-CMR6A. (3) (1) (2) Lateral electrode (-) Electrode clearance 0.7 -0.8 mm (0.028-0.031 in) 15 4. Cleaning the fuel filter • Clogged fuel filter may cause difficulty of startup or failure of engine speed increase. • Check the fuel filter regularly as follows: (1) Remove the fuel tank cap, drain the fuel to empty the tank. Check the tank inside for any foreign materials. If any, wipe clean such materials. (2) Pull out the fuel filter with wire through the oil filling port. (3) If the fuel filter surface is contaminated, clean it with gasoline. Foul gasoline must be disposed of according to the method specified by each local authority. Excessively foul filter must be replaced. (4) Reset the fuel filter in the fuel tank and tighten firmly the fuel tank cap. For replacement, contact your dealership or an authorized service agent. Fuel tank cap Fuel filter Hose clamp 5. Inspection of bolts, nuts and screws • Retighten loose bolts, nuts, etc. • Check for fuel and oil leakage. • Replace damaged parts with new ones for safety operation. 6. Cleaning of parts • Keep the engine always clean. • Keep the cylinder fins free of dust or dirt. Dust or dirt adhering to the fins will cause seizure. 7. Replacement of gaskets and packings In reassembling after the engine is dismounted, be sure to replace the gaskets and packings with new ones. Any maintenance of adjustment work that is not included and described in this manual is only to be performed by Authorized Service Agents. STORAGE WARNING • When draining the fuel, be sure to stop the engine and confirm that the engine cools down. - Just after stopping the engine, it may still hot with possibility of burns, inflammability and fire. DANGER • When the machine is kept out of operation for a long time, drain up all fuel from the fuel tank and carburetor, and keep it at a dry and clean place. Drain up fuel from the fuel tank and carburetor according to the following procedure: (1) Remove the fuel tank cap, and drain fuel completely. If there is any foreign matter remaining in the fuel tank, remove it completely. (2) Pull out the fuel filter from the refill port using a wire. (3) Push the primer pump until fuel is drained from there, and drain fuel coming into the fuel tank. (4) Reset the filter to the fuel tank, and securely tighten the fuel tank cap. (5) Then, contin...
Other models in this manual:Hair Clippers - PS-410 (3.24 mb)
Hair Clippers - PB-250.4 (3.24 mb)
Hair Clippers - PB-500 R (3.24 mb)
Hair Clippers - PS-33 (3.24 mb)