If an adapter is used to accommodate a two-prong receptacle, the adapter wire must be attached to a known .pound. Never remove the third prong. 4. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to ж that keys and adjusting wrenches are removed before turning on tool. 5. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents. 6. AVOID DANGEROUS ENVIRONMENT. Don't expose power tools to rain. Don't use power tools in damp or wet locations. Keep your work area well Illumi

4. The third hole is at the rear of the machine. An alternate method of securing the scroll saw to a supporting surface is to fasten the scroll saw to a mounting board. Then securely clamp the mounting board to a stand or workbench using two or more C-clamps. NOTE: For proper stability, the holes in the mounting board must be countersunk at the bottom so that the fastener heads are flush with the bottom surface of the mounting board. Fig. 4 A OPERATION OPERATIONAL CONTROLS AND ADJUSTMENTS STARTI

A backguard should be ordered at the same time as the range. Both must be on site at the time of installation. Order one backguard for 48" models: ZX1B48WSS-1-1/2" high backguard (required for island installations) ZX12B48WSS-12" high backguard ZX22B48WSS-22" high backguard with warming rack (2 piece) Advance Planning: Refer to dimensional drawings for appropriate placement and necessary clearances when planning the installation. • Cabinetry cannot be installed directly above the range. •

DW788/383329 8/6/02 10:35 AM Page 3 English IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US TOLL FREE AT: 1-800-4-DEWALT (1-800-433-9258) WARNING: FOR YOUR OWN SAFETY, READ INSTRUCTION MANUAL BEFORE OPERATING SAW • DO NOT WEAR GLOVES, NECKTIES, JEWELRY OR LOOSE CLOTHING • CONTAIN LONG HAIR • ALWAYS WEAR EYE PROTECTION • INSTALL BLADE WITH TEETH POINTING DOWNWARD TOWARD THE TABLE BEFORE OPERATING SAW • MAINTAIN PROPER ADJUSTMENT OF BLADE TENSION BLADE GUARD BEFORE OPE

ADVERTENCIA: LEASE ESTE INSTRUCTIVO ANTES DE GUIDE D'UTILISATION USAR EL PRODUCTO. SI TIENE DUDAS, POR FAVOR LLAME. MANUAL DE INSTRUCCIONES DW744 Table Saw Scies circulaires a table Sierra de banco English WARNING: FOR YOUR • ALWAYS • DO NOT GLOVES, NECKTIES, • CONTAIN LONG • KEEP HANDS CAUTION WHEN • ALWAYS USE SAWING • USE A “PUSH STICK” • KNOW HOW TO • ALWAYS SUPPORT FENCE OR MITER • NEVER USE FENCE • NEVER REACH AROUND • SECURELY MOUNT SAW BLADE BEFORE • NEVER REMOVE JAMMED • DO NOT EXPOSE T

5. Slide the two legs into the holes in the saw shoe as shown in Figure 4. INSTALL RIP GUIDE IN THIS DIRECTION FIG. 4 D C C 6. Adjust the front and rear scales to read the same measurement. WARNING: Both front and rear scales MUST BE set at the same rip width or serious personal injury due to kickback may occur. 7. Securely tighten front (C) and (D) rear locking screws at desired rip width. DW5100 DUAL PORT RIP GUIDE Safety Warnings WARNING: For your own safety, read the saw instruction manual b

Orbital action has a more aggressive blade motion and is designed for cutting in soft materials like wood or plastic. Orbital action provides a faster cut, but with a less smooth cut across the material. In orbital action, the blade moves forward during the cutting stroke in addition to the up and down motion. NOTE: Metal or hardwoods should never be cut in orbital action. To adjust the cutting action, move the cutting action lever (G) between the four cutting positions: 0, 1, 2, and 3. Position