Votes - 4, Average rating: 3.5 ( )

Manafacture: Admiral File size: 3.79 mb File name: Language of manual:

WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 16 WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 17 CARE AND MAINTENANCE When servicing the air conditioner, be sure to turn the mode switch to the "OFF" position and disconnect the power cord from the electrical outlet. 1. DO NOT use gasoline, benzine, thinner or other chemicals on the air conditioner as these substances may cause damage to the paint finish and deformation of plastic parts. 2. Never attempt to pour water directly in front of the unit as this will cause deterioration of the electrical insulation. Cleaning the Air Filter If the air filter becomes clogged with dust, air-flow is obstructed and reduces efficiency. The air filter should be cleaned once a month. More frequent cleaning may be necessary depending on outdoor and indoor air quality. Air Filter Removal The air filter on the above models is located behind the air intake front grill. To remove the air filter, grasp the filter handle(tab) located on the up (center) side of the air inlet grille and slide the air filter to the up. To reinstall the air filter, reverse the above procedure. CAUTION! ! DO NOT forget to install the air filter. If the air conditioner is left to operate without the air filter, dust is not removed from the room and may cause your air conditioner to fail. When the air filter inlet grill and cabinet are dirty, wipe with lukewarm water (below 104 F).Use of mild detergent is recommended. Cleaning of Air Filter 1. Remove dust clogged in the filter by tapping it or vacuum clean it. 2. Wash the filter well with lukewarm water below 40 C (104 F) while rubbing lightly. To get better results, wash it with soapy water or a neutral cleaning agent. 3. Rinse the filter well using clean water then dry completely. End-of-Season Care 1. Operate the fan alone for half a day to dry out the inside of the unit. 2. Turn off power and remove plug from wall socket. 3. Clean filter. 4. Store in a dry location. 15 WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 18 TROUBLESHOOTING GUIDE Frequently, a problem is minor and a service call may not be necessary, use this troubleshooting guide for a possible solution. When outdoor temperature is approximately 65 F or below, frost may form when unit is in cooling mode. Switch unit to FAN (only) operation until frost melts. Remove and clean filter. PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTION Air conditioner will not operate Inefficient or no cooling Noisy unit Odors Water dripping outside Water dripping inside Ice or frost build-up Low outside temperature. Unit air filter is dirty. Unit is not properly angled to allow water to drain outside. Unit must be installed on an angle for proper condensation run-off. Check the unit and make adjustments. . Formation of mold, mildew, or algae on wet surfaces. Condensation run-off is normal during hot and humid weather Add flexible tubing to redirect water flow. drain plug and drain base pan. Replace drain plug. Clean unit thoroughly. Remove Loose parts. Ina...

Download now

Please, enter two numbers from picture: