Votes - 3, Average rating: 4 ( )

Manafacture: Carrier File size: 3.79 mb File name: Language of manual:

A Reset Button B Test Button This room air conditioner is equipped with a power supply cord required by UL. This power supply cord contains state-of-the-art electronics that sense leakage current. If the cord is crushed, the electronics detect leakage current and power will be disconnected in a fraction of a second. To test your power supply cord: 1. Plug power supply cord into a grounded 3-prong outlet. 2. Press RESET. 3. Press TEST (listen for click; Reset button will trip and pop out). 4. Press and release RESET (listen for click; Reset button will latch and remain in).The power supply cord is ready for operation. NOTES: • The Reset button must be pushed in for proper operation. • The power supply cord must be replaced if it fails to trip when the test button is pressed or fails to rest. • Do not use the power supply cord as as an off/on switch. The power supply cord is designed as a protective device. • A damaged power supply cord must be replaced with a new power supply cord obtained from the product manufacturer and must not be repaired. • The power supply cord contains no use serviceable parts. Opening the tamper-resistant case voids all warranty and performance claims. INSTALLATION INSTRUCTIONS Unpack the Air Conditioner EXCESSIVE WEIGHT HAZARD Use two or more people to move and install air conditioner. Failure to do so can result in back or other injury. Remove packaging materials • Remove and properly dispose of packaging materials. Remove tape and glue residue from surfaces before turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry. • Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your air conditioner. • Handle air conditioner with care. 5 WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 8 ELECTRICAL SPECIFICATIONS 1. All wiring must comply with local and national electrical codes and must be installed by a licensed electrician. Once you have any questions regarding the following instructions, contact a licensed electrician. 2. Check available power supply and resolve any wiring problems BEFORE installing and operating this unit. 3. For your safety and protection, this unit is grounded through the power cord when plugged into a matching wall outlet. If you are not sure whether your wall outlet is properly grounded, please consult a licensed electrician. Electric Shock Hazard ! If the air conditioner has a serial plate rating of 115 volts and up to and including 7.5 amps the unit maybe on a fuse or circuit breaker with other devices. However, the maximum amps of all devices on that fuse or circuit breaker can not exceed the amps of the fuse of circuit breaker. If the air conditioner has a serial plate rating of 115 volts and greater than 7.5 amps it must have its own fuse or circuit breaker, and no other device or unit should be operated on the fuse or c...

Download now

Please, enter two numbers from picture: