Votes - 2, Average rating: 4
(
)
)
|
manual abstract
1. Turn off power to the unit by unplugging the power cord. 2. Let fireplace cool if it has been operating. 3. Remove the two screws on the top corner of screen. Pull the screen upward slightly, and then pull out. 4. Remove the four screws that secure the log set/ember bed in position. 5. Remove log set / ember bed and grate assembly. 6. Examine the bulb(s) to determine which bulbs need to be replaced. 7. While holding the socket, unscrew defective bulb(s) counterclockwise. 8. Install the new light bulb(s) by holding the socket and screwing clockwise. 9. Reinstall the log set/ember bed, grate assembly and screen. Follow the above procedure in reverse order. WARNING: Do not exceed 60 Watts per bulb. The use of higher rated bulbs may result in a fire causing property damage and personal injury. Sides....................................0 mm 0 inches Floor.....................................0 mm 0 inches Top........................................0 mm 0 inches Voltage: 120 VAC, 60 Hz Total Amps: 11.5 Amps Total Watts: 1380 Watts Heater Rating: 1200 Watts WARNING: Electrical outlet wiring must comply with local building codes and all other appliable regulations to reduce the risk of fire, electrical shock and injury. WARNING: Do not use this fireplace if any part of it has been under water. Immediatly call a quilified service technitian to inspect the fireplace and replace any part of the electrical system if necessary. 3 LOCATING YOUR ELECTRIC FIREPLACE Your new freestanding electric fireplace may be installed virtually anywhere in your home. However when choosing a location for your new electric fireplace, ensure that the general instructions are followed. For best effect results, install the electric fireplace out of direct sunlight. MAINTENANCE OF MOTORS The motors used on the fan and flame generator assembly are prelubricated for extended bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater unit is recommended. WARNING: Make sure that the power is turned off before proceeding. GLASS INFORMATION 1. Under no circumstances should this product be operated with missing or broken glass. 2. Do not strike or slam the glass. 3. Do not use abrasive cleaners to clean the glass. 4. Replacement glass is available from the manufacturer and replacement should be carried out by a qualified service person. ELECTRICAL WIRING DIAGRAM Any electrical repairs or rewiring of this unit should be carried out by a licensed electrician in accordance with national and local codes. If repairing or replacing any electrical component or wiring, the original wire routing, color coding and securing location must be followed. 4 Wire Gauge: Power Cord 14AWG Heater Element 16AWG Other Wire 18AWG Model: SFE23RE, SFE33RE Voltage: 120 VAC, 60 Hz Total Amps: 11.5 Amps Total Watts: 1380 Watts Heater Rating: 1200 Watts Operating Instructions Before programming your transmitter you must first insert three triple “AAA”batteries. Make sure...
Other models in this manual:Fireplaces - PRO-COM SFE23RE-DO (1.85 mb)
Fireplaces - PRO-COM SFE23RE-O (1.85 mb)
Fireplaces - PRO-COM SFE23RE-W (1.85 mb)
Fireplaces - PRO-COM SFE33RE-C (1.85 mb)