Votes - 3, Average rating: 4.3
(
)
)
|
manual abstract
The moisture can cause lint, dust and other airborne particles to cling to the glass surface. • Initial curing of the high temperature paint and burning off of lubricants used in the manufacturing process may result in a film on the glass. • A white coating may form on the glass as a result of impurities and minerals in the fuel. It is recommended that the glass be cleaned two or three times during each heating season, depending on the circumstances present. The following cleaning solutions are approved for use to clean glass: • Non-ammonia based household cleaner • 50%-50% mix of white vinegar & water • Gas fireplace/stove glass cleaner Inspect Glass Gasket -Visually inspect the gasket on the backside of the glass enclosure panel. The gasket surface must be clean, free of irregularities and seated firmly. Inspect Venting System The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service technician (inspectionshouldincludeensuringthatexhaust or intake passages are unobstructed and vent components are properly assembled and not damaged).Iftheventingsystemisdisassembled for any reason, a qualified service technician should follow vent installation instructions for proper reassembly and proper sealing of the venting system components. However, more frequent periodic inspections and cleanings should be performed by the homeowner. Clean Logs And Burner Carefully remove the logs (use care when handlingthe fiber logs, as they become quite fragile after curing). Vacuum out any foreign matter (lint, carbon, etc). on the burner. Ensure the burner ports are “open.” Remove any carbon deposits from the under side of the logs using a vacuum cleaner, or a soft bristled brush (i.e. paint brush). Note: Improper positioning of logs can create carbon build-up and will alter the performance of the appliance. Replacing Logs - If the logs become damaged by accident or improper handling and need replacement, use only the proper replacement logs from manufacturer (see Page 23 for ordering information). Re-Install Embers, Logs and Volcanic Stone -Carefully follow placement instructions on Pages 8 to 10 ). All logs should fit onto corresponding pins and/or log stoppers. This will ensure a proper flame and safe combustion. Inspect Wiring Refer to wiring diagrams on Page 12. WARNING Label all wires prior to discon nection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. Inspect and clean all wire connections. Ensure that there is no melting or damage. Inspection should include: • Terminals at the Valve • OFF/ON Switch • (Optional Control Switch) OFF/ON Rocker Switch, Remote Control or Remote Wall Switch Kit Inspect Burner Flame Appearance Ensure that the burner flame appearance resembles the flame shown in Figure 15 and as described in Flame Appearance and Sooting on Page 11. The Homeowner must contact a qualified service technician ...
Other models in this manual:Fireplaces - SSBV-3530CNE (4.4 mb)
Fireplaces - SSBV-3530CNE (4.4 mb)
Fireplaces - SSBV-3530CNM (4.4 mb)
Fireplaces - SSBV-3530CNE (4.4 mb)