Votes - 3, Average rating: 3.3
(
)
)
|
manual abstract
4) Fig. 4 Drilling Depth 1. Press in the clamping lever. 2. Slide the depth gauge rod backward or forward until it is set for the desired depth. NOTE: The drilling depth is the distance between the tip of the bit and the tip of the depth gauge rod. 3. Release the clamping lever. Fig. 1 WARNING To prevent personal injury, always remove the chuck thechuck after each 6 7 OPERATION WARNING To reduce the risk of injury, wear safety goggles or glasses with sideshields. Unplug the tool beforechanging accessories or makingadjustments. Selecting Action (Fig. 5) MILWAUKEE Hammer-Drills have two settings: drilling and hammer-drilling. Selector LeverFig. 5 1. For drilling, turn the hammer-drill lever towards the drill symbol . 2. For hammer-drilling, turn the hammer-drill lever towards the hammer symbol . NOTE: To engage the hammering mechanism, maintain pressure on the bit. When pressure on the bit is released, the hammering action will stop. Using Forward/Reverse Lever (Fig. 6) The forward/reverse lever can only be adjusted when the trigger is not pressed. Always allow the motor to come to a complete stop before using the forward/reverse lever. Fig. 6 Forward Reverse 1. For forward (clockwise) rotation, push the forward/reverse lever to the left (when viewed from the back of the tool) as shown. 2. For reverse (counterclockwise) rotation, push the forward/reverse lever to the right (when viewed from the back of the tool) as shown. Allow the motor to come to a full stop before reversing. NOTE: When hammer-drilling, use the tool in forward rotation (clockwise) only. Selecting Speed The speed can be changed when the tool is at a complete stop or running under no load. 1. For low speed (up to 1350 rpm), turn the speed selector to position 1. 2. For high speed (up to 2500 rpm), turn the speed selector to position 2. Starting, Stopping & Controlling Speed 1. To start the tool, pull trigger. 2. To stop the tool, release trigger. 3. To vary the speed, increase or decrease pressure to trigger. The further the trigger is pulled, the greater the speed. Operating Position the tool, grasp the handles firmly and pull the trigger. Always hold the tool securely using both handles and maintain control. This tool has been designed to achieve top performance with only moderate pressure. Let the tool do the work. If the speed begins to drop off when drilling deep holes, pull the bit partially out of the hole while the tool is running to help clear dust. Do not use water to settle the dust since it will clog the bit flutes and tend to make the bit bind in the hole. 8 APPLICATIONS WARNING To reduce the risk of electric shock, check work area for hidden pipesand wires before drilling. Drilling in Wood, Composition Materials and Plastic When drilling in wood, composition materials and plastic, select the drill operating mode. Start the drill slowly, gradually increasing speed as you drill. Select low speeds for plastics with a low melting point. Drilling in Metal When drilling in ...
Other models in this manual:Power Screwdrivers and Drills - 5378-20 (1.38 mb)
Power Screwdrivers and Drills - 5378-20 (1.38 mb)
Power Screwdrivers and Drills - 5378-20 (1.38 mb)
Power Screwdrivers and Drills - 5378-21 (1.38 mb)