Votes - 3, Average rating: 5 ( )

Manafacture: Audiovox File size: 1.06 mb File name: Language of manual:

dome light area. Align the front mounting tabs with the openings in the metal inner roof openings previously used to support the rear pod retainers. Slide bracket to rear of vehicle until flange contacts rear edge of recessed area. See Figure 7. FIGURE 7 7. Secure bracket to sheetmetal frame using four (4) # 8 x 3/4" HWH TEKS screws ( item 1 pg 2 ). Secure O.E.M. ground wire (if applicable) using one of the screws. See Figure 8. FIGURE 8 6 8. If vehicle is equipped with an electronic compass, unsnap the wire harness clip and relocate toward center of vehicle. See Figure 9. FIGURE 9 9. Remove and retain the two ( 2 ) door scuff plates on driver’s side. See Fig. 10. FIGURE 10 7 10. Remove and retain the handle which mounts to top of the “B” pillar. 11. Unsnap the cover from upper and lower mounting bracket for seat belt. Remove and retain TORX head bolt and bracket. Carefully pull panel away from side of vehicle. Unsnap upper door trim from headliner and lay aside. See Figure 11. FIGURE 11 FIGURE 12 12. Measure 7” from rear A/C control opening toward rear of vehicle. Using a razor knife, carefully cut an opening that is 4” wide x 8” long. Make sure that the 4” width is centered in the vehicle. See Figure 12. 13. Insert the 6” x 14” piece of plywood (item 8 pg 2 ) through opening and rotate 90°. 8 14. Route all accessory wiring, video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams.For Suburban applications, the suggested routing of the video system cable is as follows: · Above headliner from video system to B-pillar. · Down the B-pillar to the floor. · Route the separate power and ground leads from this point to convenience center located just forward of the emergency brake pedal. Connect red power lead to an accessory controlled source. Ground the black negative lead to the chassis. ·Route the remaining wiring ( RCA plugs, Mini AMP connector, and Remote Sensor extension ) to the video system is to be used as a television, install the antenna above the headliner per instructions included in the video system. FIGURE 13 15. Re-install the B-pillar cover, upper handle, and door trim. Reattach the seat belt bolt and re-torque to manufacturer’s recommended setting. Replace trim pieces previously removed from upper and lower seat belt. 9 II. PREPARATION OF CONSOLE FOR INSTALLATION 1. Position the O.E.M. console in the front recess area of the new console (item 4 pg 2 ). Carefully fit the two together, aligning the rear compartment hinge arms through the slots in the recess pocket area. See figure 14. FIGURE 14 2. Secure the O.E.M. compartment assembly into the console recess using (10) ten # 6 X 1/2" screws ( item 9 pg 2 ). Start all screws before tightening beginning with the front center, rear center, then alternately on each side. See figure 15. Caution: Do not overtighten screws. FIGURE 15 10 IV. INSTALLATION OF OVERHEAD CONSOLE. Caution: Do not overtighten screws. Use extra support for the console until secured ...

Download now

Please, enter two numbers from picture: