Votes - 4, Average rating: 4 ( )

Manafacture: ATON File size: 1.21 mb File name: LCR_Speakers_Manual.pdf Language of manual:

Remove speaker grille and place speaker face down. 2. Locate the speaker wire and pull through the ceiling opening. 3. Connect the speaker wire. BE SURE TO OBSERVE CORRECT POLARITY! 4. Insert the speaker into the opening in the ceiling (or Rough-in Bracket opening) and care- fully tighten each of the four clamping screws, alternating diagonally between each screw position to ensure proper fit. 5. Once the speaker is mounted in the ceiling, twist the baffle to aim the mid-range driver at the listening area. See Pointing the Mid-Range for details. 6. Aim the pivoting tweeter at the listening area. 7. Set the Treble and Bass switches. See Setting Switches for details. 8. Replace the speaker grille. Figure 3.11: Mounting Speaker In Ceiling ©2007 • All rights reserved. Storm Series LCR Theater Speakers Pointing the Mid-Range Once the audio system is connected and the speakers have been completely installed (with the grilles off), it is time to point the mid-range driver at the listening area. 1. Ensure that the LOCK screw located on the speaker baffle is loosened by turning it counter-clockwise. See Figure 3.12. LOCK Screw Figure 3.12: LOCK Screw 2. Twist the speaker baffle so that the angled mid-range driver is pointing in the desired direction. It may be easiest to utilize the bridge on which the mid-range and tweeter are mounted to physically turn the speaker. 3. Turn the LOCK screw clockwise to tighten the speaker baffle and lock it in place. © 2007 • All rights reserved. Storm Series LCR Theater Speakers Mounting Speakers in Wall (Pre-Construction or Retro-Fit) 1. Remove speaker grille and place speaker face down. 2. Locate the speaker wire and pull through the wall opening. 3. Connect the speaker wire. BE SURE TO OBSERVE CORRECT POLARITY! 4. Insert the speaker into the opening in the wall (or Rough-in Bracket opening) and care- fully tighten each of the six clamping screws, alternating diagonally between each screw position to ensure proper fit. 5. Aim the pivoting tweeter at the listening area. 7. Set the Treble and Bass switches. See Setting Switches for details. 8. Replace the speaker grille. Figure 3.13: Mounting Speaker In Wall Setting Switches Once the speakers are wired, mounted, and positioned correctly, use the Bass and Treble switches to fine-tune the speakers based on local environmental variables such as hardwood floors, thick draperies, etc. Select the “+” position to increase Bass/Treble response or select the “-” position if no increase or decrease is desired. BASSBASS TREBLE TREBLE Figure 3.14: Bass & Treble Switches ©2007 • All rights reserved. Storm Series LCR Theater Speakers 4. Specifications A83C System Type ...........................................................................................................................................................3-Way Ceiling Woofer .................................................................................................................................................................8" Woven Kevlar Midrange .........................................................................................................................................................2.5" Woven Kevlar Tweeter ....................................................................................................................................................3/4" Pivoting Titanium Crossover .....................................................................................................................2nd Order Custom Q @ 250Hz & 3kHz Switches .....................................................................................................................................................................Treble/Bass Impedance ....................................................................................................................................................................... 6 Ohms Sensitivity ........................................................................................................................................................................... 92dB Frequency Response ........................................................................................................................................28Hz to 22kHz Power Handling ........................................................................................................................................................ 175 Watts Cutout Dimensions ................................................................................................................................... 11 1/4" (286mm) Outer Frame Dimensions ....................................................................................................................... 12 1/8" (308mm) Mounting Depth ........................................................................................................................................6 1/16” (178mm)* Pre-Construction Bracket ...........................

Download now

Please, enter two numbers from picture: