BATTERY VOLTAGE 6 12 18 24 INITIAL CHARGE RATE SETTING AMPS CHARGE VOLTS CHARGE LO 6V LO 12V LO 18V LO 24V 12V 6V 12V HI LO 2 LO 2 23 4 HI LO HI HI LO 24V 18V 12V CRANK ASSIST VOLTS/AMPS CHARGE 23.6 11.8 5.9 1.110 23.8 11.9 5.95 1.140 24.2 12.1 6.05 1.185 24.8 12.4 6.2 1.225 75% 50% 25% DEAD Open Circuit Voltage 24V Open Circuit Voltage 12V Open Circuit Voltage 6V Specific Gravity STATE OF CHARGE STATE OF CHARGE TABLE Cold Cranking Amps Reserve Capacity Ampere Hours BATTERY SIZE 60 90 350 80+ 10

Push the axle through the base, place wheel on opposite side. Tap axle nut onto the axle with a hammer. OPERATING INSTRUCTIONS CAUTION - This battery charger must be fully assembled before operating. Failure to do so may result in risk of injury. USE OF INSTRUMENT PANEL: The CHARGE TIME timer has an OFF position, a CONTINUOUS CHARGE position and a timed charge range from 0 to 90 minutes. a. OFF - Always make sure the timer is in the OFF position before connecting or disconnecting the clamps from

Save these instructions. This manual containsimportant safety, operating and maintenance instructions. INTRODUCTION Model 6065 battery charger is designed to charge one to ten 12 volt batteries in parallel. The multiple charge rates allow batteries to be slow charged or fast charged at a rate not to exceed 30 amps output of the charger. The voltmeter allows you to adjust the charge rate to compensate (see charging instructions). This unit is not intended to be used as a car starting unit. The ou

Digital voltmeter and ammeter improve accuracy and reliability. Use Model 6075 bus bar sets as needed. [Ë1 ASSOCIATED MODEL 6068 ©æss • « (6068) (6065) USA Model 6065 Parallel Charger Charges 1 to 10 batteries, in parallel, in less than 24 hours. UL listed. 16 charge rates for precise charging. Patented multi-diode rectifier with deep reserve capacity. Use Model 6075 bus bar that includes 10 pairs of charging leads. USA (6086) (6075) Model 6075 Bus Bar Bus Bar set for parallel char

Can be wall-mounted or on a stationary bench. 16 charge rates for precise charging. Each battery accepts charge required,depending on size, state of charge and temperature. Engineered so that an initial high charge rate tapers down to a safe finishing level. Isolated transformer and a heavy-duty diode rectifier with deep reserve capacity are standard features. Digital voltmeter and ammeter improve accuracy and reliability. Use Model 6075 bus bar sets as needed. [Ë1 ASSOCIATED MODEL 6068 ©æss

Insulated fiberglass backboard with 10 pairs DC charging leads, 10 gauge, 36” long with 300 Amp insulated safety clamps. Comes with three-foot 4 AWG cables to connect to charger or additional bus bars. Model 6086 Battery Charging Rack Battery charging rack stores up to 15 batteries. Convenient three-shelf, heavy-gauge steel construction rack with 10 pairs of charging leads. Insulated storage bars and connections ensure there are no live electrical connections. Shelves have durable 1/8” polypro

Never allow the clamps to touch each other. b. When attaching a clamp to a battery post, twist or rock the clamp back and forth several times to make a good connection. This tends to keep the clamp from slipping off the terminals and helps to reduce the risk of sparking. 6. STOP/GO LITE INSTRUCTIONSWhen used properly, the STOP/GO LITE will indicate whether the clamp connections will be correct. Connect the Positive (RED) clamp to the Positive (POS,+) battery post. Touch the contact button of the

Designed to meet the needs of the most demanding professional with 16 rates of charge and 75 Amp continuous charge with 375 Amps Crank Assist at 12 Volts. 25% more engine start than previous model. UL and CSA listed for indoor and outdoor use. “SAFE IN ANY WEATHER”. (6002 Charger Specilications M0DÜ IS ll M B i R 6001 A 6002 B Jl CON IINUOUS RBTIlUß )00/75 A ■ 100/80 A mnmiiRMiP. RECTIFIER SHIPPING LIMITED DIMENSIONS WARRANT! mmoi 5 Years 5 Years 26"xl6"xl4’ 26"xl6"xl4' 58 lbs

Designed to meet the needs of the most demanding professional with 16 rates of charge and 75 Amp continuous charge with 375 Amps Crank Assist at 12 Volts. 25% more engine start than previous model. UL and CSA listed for indoor and outdoor use. “SAFE IN ANY WEATHER”. (6002 Charger Specilications M0DÜ IS ll M B i R 6001 A 6002 B Jl CON IINUOUS RBTIlUß )00/75 A ■ 100/80 A mnmiiRMiP. RECTIFIER SHIPPING LIMITED DIMENSIONS WARRANT! mmoi 5 Years 5 Years 26"xl6"xl4’ 26"xl6"xl4' 58 lbs

Follow the duty cycle on the unit. NOTE: DO NOT crank the engine more than 20 seconds in any five minute period; excessive cranking may overheat and damage the starter. If the vehicle fails to start, while waiting for the starter to cool, allow the charger to continue to charge the battery. Turn the switch to OFF and remove the AC power cord from the electric outlet before disconnecting the DC clamps. 3 22. MAINTENANCE INSTRUCTIONS This charger requires minimal maintenance. As with any appliance