Votes - 1, Average rating: 4 ( )

Manafacture: Avanti File size: 85.35 kb File name: 0f20bd2d-bda0-4a16-b350-056a55d7a632.pdf Language of manual:

INSTALLATION REQUIREMENTS Remove all packing material and tape. Install on a level floor or well-supported counter. Avoid any direct sunlight, heat source, or moisture. This refrigerator is designed to be freestanding — that is, the appliance is to be installed at least 1.” from the wall and the cabinet bottom is at least .” to 1” above the floor or carpet, in order to let the air circulate freely around the refrigerator. If this appliance is recessed, built-inor otherwise enclosed to restrict airflow, then all warranties stated herein are null and void. ELECTRICAL REQUIREMENTS 120 volts, 60 Hz. ELECTRICAL GROUNDING (for 120-volt models only) Must be grounded. Uses 110-120 volts, 60 Hz. (60 cycles A.C.) Do not use extension cord. Use three-prong plug, with three-prong grounded wall outlet. Unless the above grounding method is followed, you are not protected against severe or lethal shock, in the event of a short circuit of an electrical component or wiring of refrigerator. CAUTION Should you unplug refrigerator, allow at least three minutes before restarting in order to allow the start relay to function properly. USE AND CARE INFORMATION • TIPS ON EVERYDAY USE AND CARE TO CONTROL TEMPERATURE: Start by setting control on 3. Wait 24 hours for refrigerator to cool. Higher number is colder. Fresh food section should be as cold as possible without freezing vegetables or milk. Adjust as necessary. FOR ALL CLEANING: Mix 2 tablespoons baking soda or mild soap with 1 quart warm water. No strong cleaners, scouring powder or pads should be used. • THINGS TO REMEMBER 1. Allow 24 hours for your refrigerator to reach a new temperature setting. 2. The motor will start and stop often. It must do so in order to maintain the temperature you select. 3. Keep your refrigerator reasonably level. 4. Unplug refrigerator before doing anything with its electrical system (even changing a light bulb). • BEFORE CALLING FOR SERVICE Check plug and outlet. Test outlet with lamp or other device. Be sure control is on. Read all Use & Care Information. Your questions may be answered. If not, find your model number (on upper back of refrigerator or inside the refrigerator affixed to the inner liner surface on the right-hand side). Refer your model number and the problem to Absocold Corporation at (800) 843-3714 or (765) 935-7501. DANGER—ELECTRICAL SHOCK HAZARD. Disconnect power before servicing. ENERGY SAVING TIPS - WAYS TO SAVE POWER, SAVE MONEY, AND STILL ENJOY YOUR REFRIGERATOR • Reduce door openings. • Don’t put hot foods in refrigerator. • Close the door as soon as you can. • Keep your refrigerator away from stoves and other heat sources. • Adjust temperature control to warmer setting when practical. WARNING! • Your refrigerator should be connected directly to a grounded electrical wall outlet. No extension cords, multi-connection bars, etc. should be used. • In case of prolonged power outage or an electrical disconnect of any type, please check your refrigerator for spoiled f...

Download now

Please, enter two numbers from picture: