Votes - 0, Average rating: 0 ( )

Manafacture: Bosch File size: 2.38 mb File name: Language of manual:

Proceed as follows: 1. Before cleaning: Switch the appliance off. 2. Pull out mains plug or switch off fuse. 3. Take out the frozen food and store in a cool location. Place the ice pack ( if enclosed) on the food. 4. Clean the appliance with a soft cloth, lukewarm water and a little pH neutral washing- up liquid. The rinsing water must not run into the light. 5. Wipe the door seal with clear water only and then wipe dry thoroughly. 6. After cleaning reconnect and switch the appliance back on. 7. Put the frozen food back in the freezer compartment. en Interior fittings All variable parts of the appliance can be taken out for cleaning. Take out glass shelves Pull the glass shelves forwards and take out. Removing the container Fig. 9 Pull out the container all the way, lift at the front and remove. Taking out the frozen food container Fig. 8 Pull out the frozen food container all the way, lift at the front and remove. Light ( LED) Your appliance features a maintenance- free LED light. These lights may be repaired by customer service or authorised technicians only. Tips for saving energy ¦ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source ( e.g. radiator, cooker) . If required, use an insulating plate. ¦ Allow warm food and drinks to cool down before placing in the appliance. ¦ Thaw frozen food in the refrigerator compartment and use the low temperature of the frozen food to cool refrigerated food. ¦ Open the appliance as briefly as possible. ¦ Occasionally clean the rear of the appliance to prevent an increased power consumption. ¦ If available: Fit wall spacers to obtain the indicated energy rating of the appliance ( see Installation instructions). A reduced wall gap will not restrict the function of the appliance. The energy rating may then increase slightly. The gap of 75 mm must not be exceeded. ¦ The arrangement of the fittings does not affect the energy rating of the appliance. Operating noises Quite normal noises Droning Motors are running ( e.g. refrigerating units, fan) . Bubbling, humming or gurgling noises Refrigerant is flowing through the tubing. Clicking Motor, switches or solenoid valves are switching on/off. Cracking Automatic defrosting is running. en Preventing noises The appliance is not level Please align the appliance with a spirit level. Use the height- adjustable feet or place packing underneath them. The appliance is not free-standing Please move the appliance away from adjacent units or appliances. Containers or storage areas wobble or stick Please check the removable parts and re- insert them correctly if required. Bottles or receptacles are touchingeach other Move the bottles or receptacles slightly away from each other. Eliminating minor faults yourself Before you call customer service: Please check whether you can eliminate the fault yourself based on the following information. Customer service will charge you for advice – even if the appliance is still under guarantee! Fault Possible cause Remedial action Temperature differs greatly from the set value. In some cases it is adequate to switch off the appliance for 5 minutes. If the temperature is too high wait a few hours and check whether the temperature has approached the set value. If the temperature is too low check the temperature again the next day. The light does not function. The LED light is defective. See chapter “ Light (LED)” section. Appliance was open too long. When the appliance is closed and opened, the light is on again. Light is switched off after approx. 10 min. en Fault Possible cause Remedial action Controls have reduced luminosity. When the appliance is not used for some time, the display on the fascia switches to energy saving mode. As soon as the appliance is again used, e. g. the door is opened, the display switches back to normal illumination. Displays do not illuminate. Power failure; the fuse has been switched off; the mains plug has not been inserted properly. Connect mains plug. Check whether the power is on, check the fuses. Warning signal sounds. The alarm button is lit. Fault – the freezer compartment is too warm! To switch off the warning signal, press the alarm button 2. Fig. 2/2 Appliance is open. Close the appliance. Ventilation openings have been covered. Ensure that there is adequate ventilation. Too much food was placed in the freezer compartment at once. Do not exceed max. freezing capacity. When the fault has been eliminated, the alarm button goes out shortly afterwards. en Fault Possible cause Remedial action Warning signal sounds. Alarm button flashes. Fig. 2/2 Fault – the freezer compartment is too warm! Frozen food is at risk! To switch off the warning signal, press the alarm button 2. Alarm button stops flashing. Note Frozen food which has started thawing or which has thawed can be refrozen if meat and fish were above + 3 ° C for not more than one day or other frozen food for not more than three days. If ...

Download now

Please, enter two numbers from picture: