Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
Glass cover for the oven Hot water and a little soap: light Clean with a dishcloth. The seal Hot water and a little soap: Do not remove! Clean with a dishcloth. Do not rub. Zone Cleaning products Wire shelves or rails Hot water and a little soap: Soak and clean using a dishcloth or brush. Sliding guides Hot water and a little soap: Clean with a dishcloth or a brush. Do not leave this to soak or wash in a dishwasher. Accessories Hot water and a little soap: Soak and clean using a dishcloth or brush. Light The oven light can be turned on manually to facilitate cleaning. Connecting the oven light Turn the function control knob to the N setting. The light will come on. The temperature control knob must be turned off. Turning the oven light off Turn the function control knob to the Uposition. Removing and refitting the wire shelves or leftand right hand side rails The wire shelves or left and right hand side rails can be removed for cleaning. The oven must be cold. Release the guides or rails 1. Lift the front of the guide or rail and release it (figure A). 2. Then pull the guide or rail forwards completely and remove it (figure B). Clean the guides or rails with detergents and a sponge. The use of a brush is recommended for stubborn stains. Install the wire shelves or rails 1. First insert the shelf or the rail in the rear groove by pushing it back slightly ( figure A) 2. then insert it in the front groove (figure B) . Wire shelves or rails can be adjusted on the left and right hand side. Their curvature should always be face down. 8 Unhooking and hanging the oven door The front panel can be unhooked to help remove the oven door and clean the glass panels. The oven door hinges are fitted with a locking lever. The door cannot be unhooked if the locking lever is closed (figure A). Once the locking lever has been opened to unhook the door (figure B), the hinges will be locked in position. This prevents the door from suddenly closing. : Risk of injuries.! The hinges may close suddenly if they are not locked in position by the lever. Note that the locking levers are always closed, apart from when unhooking the door, when the levers must be open. Unhooking the door 1.Fully open the oven door. 2.Remove both locking levers located on the right and left hand sides (figure A). 3.Fully close the oven door as far as possible (figure B). Grip the left and right hand sides of the door with both hands. Close the door slightly more and remove it. Hanging the door Rehang the door by following the same steps but in reverse order. 1.When refitting the door, check that both hinges are positioned exactly inside their respective openings (picture A). 2. The bottom groove of the hinges must fit snugly on both sides. The door may be left crooked if the hinges are not mounted properly. 3.Reclose the attachment levers (picture C). Close the oven door. : Risk of injuries.! Do not touch the hinges; the door might accidentally fall or a hinge might suddenly close. Notify the Technical Assistance Service. Fitting and removing the glass panels The glass panels of the oven door can be removed to make cleaning easier. Dismantling 1.Unhook the oven door and place it on a cloth with its handle pointing downwards (Figure A). 2.Firstly screw the two bottom screws followed by the two top screws clockwise (Figure B). 3.Remove the cover (Figure C). The dismantled items should not be washed. Clean the glass using a glass cleaning product and a soft cloth. : Risk of injury! Scratched glass in the appliance door may develop into a crack. Do not use a glass scraper, sharp or abrasive cleaning aids or detergents. In s t a l li n g 1. Reattach the cover ( Figure A) . 2. Firstly screw the two bottom screws followed by the two top screws (Figure B). 3. Refit the oven door. Once the glass panels have been correctly fitted, the oven is ready to use. Troubleshooting Quite often, when there is a malfunction, it is usually a small irregularity which is easy to rectify. Before contacting the Technical Assistance Service, try to determine the cause of the fault using the following table. Troubleshooting table Fault Possible cause Solution/ advice The oven does not work. The fuse has blown. Check the condition of the fuse in the fuse box. Power cut Check that the light in the kitchen and other household appliances are working. The oven does not heat up. The timer is at the 0 setting. Turn the timer to the Z setting. : Risk of electric shock! Incorrect repairs can be dangerous. Repairs can only be carried out by qualified personnel from the Technical Assistance Service. Changing the oven bulb If the oven light bulb is damaged it must be replaced. Special 25 W, E14, 220 V- 240 V heat-resistant light bulbs (to 300 . C temperature) can be obtained from the Technical Support Service or in specialist shops. Only use this type of bulb. : Risk of electrical discharge and the resulting shock. ! Disconnect the appliance from the mains. Ensure that this is turned of...
Other models in this manual:Refrigerators - 3HE503NM/01 (423.6 kb)
Refrigerators - 3HE503XM/01 (423.6 kb)