Votes - 4, Average rating: 4 ( )

Manafacture: Samsung File size: 726.24 kb File name: Language of manual:

Other manuals for this model:

Refrigerators - RS20NASL (759.86 kb)

Refrigerators - RS20NASL (758.03 kb)

Refrigerators - RS20NASL (686.85 kb)

Refrigerators - RS20NASL (558.95 kb)

Store food in the freezer/refrigerator. • Wait for at least two or three hours after plugging your appliance in before storing food and other items inside. Allow sufficient space to install the appliance on a flat surface. • If your appliance is not level, the internal cooling system may not work properly 12 INSTALLATION OF THE REFRIGERATOR LEVELLING When you adjust the level of the freezer/refrigerator, set the front legs slightly higher than the rear legs, so that you can open and close the door more easily. First disassemble the leg cover and then adjust the level of the freezer/refrigerator. If your freezer/refrigerator tilts to the left, turn the left adjust- ing leg. If your freezer/refrigerator tilts to the right, turn the right adjust- ing leg. EARTHING THE APPLIANCE WARNING The appliance must be earthed before use. You must earth the freezer/refrigerator to prevent any power leakage or electric shock caused by current leakage from the appliance. • Never use gas pipes, telephone lines or other potential lightning rods as earths. INSTALLATION INSTRUCTIONS If you are using a power plug that is not already earth- ed. • Connect one end of the earthing wire (yellow/green or green) to the earth screw and the other end to a steel or copper pipe, such as a water pipe. Earth screw Earthing wire Copper pipe 13 14 ADJUSTING THE CLEARANCE BETWEEN THE DOORS Adjusting the small step difference between doors. If the door of freezer is lower than that of the refrigerator. If the door of freezer is higher than that of the refrigerator. 3) After adjusting the doors, turn the nut () turn clockwise( ) until the lower end of the bolt, then tighten the bolt again with wrench (.) to fix the nut(). If you do not fix the nut ()firmly, the bolt (.) may be released. 2) Please adjust the height difference between the doors turning the bolt (.) turn clockwise( ) or counter clockwise ( ). When you turn clockwise ( ), the door goes up. . WRENCH Adjustment part . NUT . BOLT Adjustment part . WRENCH . NUT . BOLT . NUT . BOLT . WRENCH . WRENCH . WRENCH . BOLT . BOLT Please open the doors and adjust the doors as follows: 1) Release the nut () on the lower hinge until the upper end of the bolt (.). When you release the nut(), use enclosed hex wrench (.) to turn the bolt(.) a little counterclockwise to make the nut() loose with your fingers. . BOLT . WRENCH . NUT NOTE NOTE NOTE TROUBLESHOOTING The freezer/refrigerator does not work at all or it does not chill sufficiently • Check that the power plug is properly connected. • Check that the power plug fuse has not blown. • Is the temperature control set to the proper temperature? • Is the freezer/refrigerator in direct sunlight or located near a heat source? • Is the back of the freezer/refrigerator too close to the wall? The food in the refrigerator is frozen • Is the temperature control set to the proper temperature? • Is the temperature in the room too low? • Did you put food with a high water content near the coldest part ...

Download now

Please, enter two numbers from picture: