Votes - 5, Average rating: 4.2 ( )

Manafacture: Carrier File size: 190.9 kb File name: Language of manual:

Household appliances sold in the EU also meet 96/57/EEC (energy efficiency requirements) as amended. The rating plate, which is placed either at the back or inside the appliance, see fig. (7) page 13, provides various technical information as well as type and serial number. 7 9. INSTALLATION See drawings (1) and (2) page 12. Install the cabinet in a dry place and so that it is not exposed to direct sunlight or any other source of heat. Place the cabinet in a level position. This is easily achieved by adjusting the adjustable feet at the front edge of the base. The cabinet should not rest against a wall on its hinged side. When placing the cabinet on a carpet or on a wooden floor you should adjust it once more after some time as the cabinet might settle in soft foundations. The cabinets can be built in or put side by side, see fig. (2b) page 12. KF models put side by side with other models require a distance of 2 inches between the appliances. For sufficient airflovy around the cabinet it is necessary to have a 4inches high air duct right above the appliance, see fig. (2a) and (2b) or an air duct that leeds the air up over the top cupboard, see fig. (2c). Make sufficient space for door opening as to draw the baskets out, see fig. (2e). The dimensions for building in are noted on the drawings. During a storm the electricity supply might be cut off. You should be aware of this when installing the appliance in weekend cottages or elsewhere where you would not immediately observe that the power has been cut off. Construction and details in the accessories are subject to alteration without previous notice. If the cabinet is to be adjusted: See drawings (1) page 12 Take hold of the front panel with both hands. Then lift up the front panel and turn out the bottom part. Adjust the tilt of the unit See drawings (1) page 12 by turning the adjustable feet with a 13 mm spanner. 10. CHANGE OF HINGE SIDE See drawings page 14. 1. Dismantle the top hinge. This one is to be used later as top hinge at the opposite side. Lift off the top door. 2. Dismantle the middle hinge. Lift off the bottom door. Mount the hinge screws again. 3. Dismantle the screws in the middle of the new hinge side. Mount the bottom door and scrfew on the middle hinge. 4. Remove the kick panel. a) Only for appliances with a door closer on the bottom door. The door closer is moved to the second hole. b) The bottom hinge is dismounted at the 3 screws. The hinge is turned 90° and mounted on the opposite side. 5. Adjusting the bottom door: Loosen the 3 screws in the bottom hinge and push the bottom hinge to the required side. Tighten the screws and mount the kick panel. 6} The kick panel is mounted and the hole plugs are mounted on the opposite sideg. 7. Ajustment of the top door: loosen the screws in the hinge above the door, loosen the hinge above the door and turn the hinge to the wanted side. Tighten the screws. 8. Move the handle. DISPOSAL OF THE APPLIANCE The...

Download now

Please, enter two numbers from picture: