Votes - 2, Average rating: 4 ( )

Manafacture: AEG File size: 102.93 kb File name: 236331en.pdf Language of manual:

If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance. Your appliance needs air For safety reasons, minimum ventilationmust be as shown Fig. Attention: keep ventilation clear of obstruction; Changing the light bulb Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. 1. 2. 3. 4. 5. Light bulb data: 220-240 V, max. 15 W Unplug the mains plug. To change the light bulb press on the rear hook and at the same time slide the cover in the direction indicated by the arrow. Change the defective light bulb. Refit the light bulb cover. Put the refrigerator back into opera- tion. Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), accident prevention regulations for refrigeration appliances (VBG 20) and the regulations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance. The refrigerant circuit has been checked for leaks. This appliance is in accordance with the following EU guidelines: – 73/23/EWG dated 19 February 1973 - low voltage guidelines. – 89/336/EWG dated 3 May 1989 (including guideline change notice 92/31/EWG) - EMV guideline Malfunction The food is too warm. Interior lighting does not work. Heavy build up of frost, possibly also on the door seal. Unusual noises. The compressor does not start immediately after changing the temperature setting. Water on the floor or on storage shelves. Possible Cause Temperature is not properly adjusted. Door was open for an extended period. A large quantity of warm food was placed in the appliance within the last 24 hours. The appliance is near a heat source. Light bulb is defective. Door seal is not air tight (possibly after changing over the hinges) . Appliance is not level. The appliance is touching the wall or other objects. A component, e.g. a pipe, on the rear of the appliance is touching another part of the appliance or the wall. This is normal, no error has occurred. Water drain hole is blocked. Remedy Please look in the "Initial Start Up" section. Open the door only as long as necessary. Turn the temperature regulator to a colder setting temporarily. Please look in the "Installation location" section. Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand such that it sits correctly. Readjust the feet. Move the appliance slightly. If necessary, carefully bend the component out of the way. The compressor starts after a period of time. See the "Cleaning and Care" section. Rehingeing the door The appliance’s door has been locked in position for t...

Download now

Please, enter two numbers from picture: