Votes - 4, Average rating: 4 ( )

Manafacture: AEG File size: 605.53 kb File name: 720331EN.pdf Language of manual:

Take care of not to damage the cooling system. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. 12 12 Care and cleaning It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. About 12 hours prior to defrosting, set the Temperature regulator toward higher settings , in order to build up sufficient chill reserve for the interruption in operation. To remove the frost, follow the instructions below: 1. Switch off the appliance. 2. Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. CAUTION! Do not touch frozen goods with wet hands. Hands can freeze to the goods. 3. Leave the door open and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water In order to speed up the defrosting process, place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that break away before defrosting is complete. 4. When defrosting is completed, dry the interior thoroughly and keep the scraper for future use. 5. Switch on the appliance. 6. After two or three hours, reload the previously removed food into the compartment. What to do if… 13 Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: • disconnect the appliance from electricity supply • remove all food • defrost 5)and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution The appliance does not op-The appliance is switched off. Switch on the appliance. erate. The lamp does not operate. The lamp does not work. The mains plug is not connected to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. The lamp is in stand-by. Connect the mains plug to the mains socket correctly. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The compressor operates The temperature is not set cor-Set a higher temperature. continually. rectly. The door is not closed correctly. Refer to "Closing the door". The door has been opened too Do not keep the door open lon frequently. ger than necessary. 5) If foreseen. 14 14 What to do if… Problem Possible cause Solution Water flows on the rear plate of the refrigerator. The product temperature is too high. The room temperature is too high. During the automatic defrosting process, frost defrosts on the rear plate. Water flows into the re-The water outlet is clogged. Clean the water outlet. frigerator. Products prevent that water Make sure that products do not flows into the water collector. touch the rear plate. Water flows on the The melting water outlet does Attach the melting water outlet ground. not flow in the evaporative tray to the evaporative tray. above the compressor. The temperature in the ap-The temperature regulator is Set a higher temperature. pliance is too low. not set correctly. The temperature in the ap-The temperature regulator is Set a lower temperature. pliance is too high. not set correctly. The door is not closed correctly. The product temperature is too hi...

Download now

Please, enter two numbers from picture: