Votes - 3, Average rating: 4 ( )

Manafacture: Amana File size: 455.85 kb File name: 337848EN.pdf Language of manual:

Take care of not to damage the cooling system. What to do if… 13 Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: • disconnect the appliance from electricity supply • remove all food • defrost4) and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. There are some sounds during normal use (compressor, refrigerant circulation). 4) If foreseen. 14 14 What to do if… Problem Possible cause Solution The appliance is noisy The appliance is not supported Check if the appliance stands staproperly ble (all the four feet should be on the floor) The appliance does not The appliance is switched off. Switch on the appliance. operate. The lamp does not operate. The mains plug is not connected Connect the mains plug to the to the mains socket correctly. mains socket correctly. The appliance has no power. Connect a different electrical ap- There is no voltage in the mains pliance to the mains socket. socket. Contact a qualified electrician. The lamp does not work. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The compressor operates The temperature is not set cor-Set a higher temperature. continually. rectly. The door is not closed correctly. Refer to "Closing the door". The door has been opened too Do not keep the door open longer frequently. than necessary. The product temperature is too Let the product temperature de- high. crease to room temperature before storage. The room temperature is too Decrease the room temperature. high. The compressor does not This is normal, no error has oc-The compressor starts after a peri start immediately after curred. od of time. pressing the COOLMATIC switch, or after changing the temperature. Water flows on the rear During the automatic defrosting This is correct. plate of the refrigerator. process, frost defrosts on the rear plate. Water flows into the re-The water outlet is clogged. Clean the water outlet. frigerator. Products prevent that water Make sure that products do not flows into the water collector. touch the rear plate. The temperature in the The temperature regulator is not Set a higher/lower temperature. appliance is too low/high. set correctly. The door is not closed correctly. Refer to "Closing the door". The product temperature is too Let the product temperature de- high. crease to room temperature before storage. Technical data 15 Problem Possible cause Solution Many products are stored at the Store less products at the same same time. time. The temperature in the refrigerator is too high. Upper or lower square is shown in the temperature Display. There is no cold air circulation in the appliance. An error has occurred in measuring the temperature. Make sure that there is cold air circulation in the appliance. Call your service representative (the cooling system will continue to keep food products cold, but temperature adjustment will not be possible). Keep pressed approximately 10 sec. the OK button since a long sound of buzzer is heard and the Display shut off for a short while: appliance start works regularly. dEMo appears on the Display. The appliance is in demonstration mode (dEMo). Replacing the lamp The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device. Contact your Service Center Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Voltage 230-240 V Frequency 50 Hz The technical in...

Download now

Please, enter two numbers from picture: