Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Replacing the fleece grease filter: . During normal operation (daily 1 to 2 hours) the fleece grease filter must be replaced every 8 to 10 weeks. Replace printed fleece grease filters at the latest when the coloured print dissolves. . Use only original filters. These comply with the safety regulations and ensure optimum function. Disposal of the old fleece grease filter: . Fleece grease filters do not contain any harmful substances. They can be disposed of as bio-degradable waste. Filters and maintenance Removing and installing the metal filter: 1. Press in the interlocks on the left and right sides of the filter grille. 2. Remove the filter grille. 3. Remove the wire grille and the saturated filter mats. 4. Clean the filter grille and insert a new filter mat. 5. Clamp the filter mat with the wire grille. 6. Re-insert the filter grille. The interlocks must lock into position on the left and right sides. Metal grease filter: The filter mats consist of non-flammable material. Warning: A build up of greasy residue increases flammability, and the function of the extractor hood may be impaired. Important: Replace the metal grease filter in good time, otherwise there is a risk of fire from the heat which accumulates during deep-fat frying or roasting. Cleaning the metal grease filter: . During normal operation (daily 1 to 2 hours) the metal grease filter must be replaced every 8 to 10 weeks. . The metal grease filter can be cleaned in the dishwasher. Slight discoloration may occur. Important: Do not clean heavily saturated metal grease filters with other dishes. . If cleaning by hand, soak the grease filters in a hot soapy solution. Then brush off any residual grease, rinse thoroughly and leave to dry. . Use only original filters. These ensure optimum function. Filters and maintenance Removing and installing the metal filter (See details for removing/inserting the fleece filter): 1. Clean the filter grille and the filter mats. 2. Re-insert the cleaned filter mats and clamp them with the wire grille. Ensure that there is no gap in the middle. 3. Insert the activated carbon filter at the rear, fold up and lock into position on the left and right with the wing nuts. The lugs on the left and right sides of the activated carbon filter are folded in for the 50 cm wide extractor hood. They must be folded up for the 60 cm and 90 cm wide extractor hoods. Activated carbon filter: For binding the odorous substances in circulating-air mode. (See details for removing/inserting the fleece filter.) 1. Insert the screws through the wing nuts and sleeves and screw the screws into the left and right sides of the intermediate base (required only during the initial installation). Screws, wing nuts and sleeves are enclosed with the activated carbon filter –. 2. Using a screwdriver or similar tool, press the two lugs on the housing inwards (required only during the initial installation). Replacing the activated carbon filter: . During normal operation (daily 1 to 2 hours)...
Other models in this manual:Range Hoods - 2MBK60/02 (1.7 mb)
Range Hoods - 2MBK60/03 (1.7 mb)
Range Hoods - 2MBK60/04 (1.7 mb)
Range Hoods - 2MBK60W/02 (1.7 mb)