Votes - 0, Average rating: 0
(
)
)
|
manual abstract
An activated carbon filter must be installed to bind odours in circulating-air mode (see ”Removing and installing the grease filters”). The complete installation set as well as the replacement filters are available from specialist outlets, customer service or the Online Shop. The accessory number can be found at the end of the operating instructions. Appliance dimensions Circulating air Switching the electronic control to circulating air mode • The extractor hood must be connected and switched off. • Simultaneously press buttons-andr untilais displayed. • Repeatedly press buttons-andr to switch the electronic control back to exhaust air mode by (display#). Operation Grease filter saturation display Display fan settings Fan run-on Light Fan On/Off Switch back fan Switch on and increase fan Intensive setting NOTE:It is recommended to switch on the blower when you start cooking and not to switch it off again until several minutes after you have finished cooking. In this way the kitchen fumes are removed most effectively. Switching on the fan and selecting the fan settings • Press button-. • Press button +.The fan setting is increased by one. • Press button –.The fan setting is reduced by one. Switching off the fan • Press button-. Intensive setting The Intensive settingcgenerates maximum performance. It can be used if thick fumes or strong odours occur temporarily. • Keep pressing button +untilcis displayed. • If the Intensive setting is not switched off by hand, the fan automatically switches back to setting 2 after 10 minutes. Fan run-on • Press button r. • The fan runs for 10 minutes at the selected setting. The r symbol is lit on the display. Then the fan switches off automatically. Light • The light can be switched on and off independently of the fan. • To adjust the luminosity, hold down button0 until the required luminosity is obtained. Saturation displays • When the grease filters or the activated carbon filter are saturated, a signal sounds for 6seconds after the fan is switched off. DisplayJoraJ is lit. Exhaust-air mode:J Circulating-air mode:aJ The grease filters should now be cleaned or the activated carbon filter changed. • To cancel the display, press button -. Switching the acoustic signal off and on • When a button is pressed, an acknowledgement signal sounds. • To switch off the acoustic signal, simultaneously press buttons -and+for approx. 3 seconds. An acknowledgement signal sounds. • To switch on the acoustic signal, repeat the process. Cleaning and care LOOKINGAFTERTHEAPPLIANCE • Suitable cleaning agents and care products for your appliance can be purchased via the Hotline or from the Online Shop (see cover page). Appliance surfaces NOTE: Observe the warranty regulations in the enclosed service booklet. • The appliance surfaces and controls are scratch-sensitive.Therefore observe the following cleaning instructions: – Avoid cleaning the extractor hood with dry cloths, abrasive sponges, scouring agents, cleaning agents containing sand, soda, acid, chlorine or any other aggressive substances. – Clean the appliance surfaces and controls with a soft, damp cloth, washing-up liquid or a mild window cleaner only. – Do not scrape off...
Other models in this manual:Range Hoods - D72F58N0GB/01 (693 kb)
Range Hoods - D72F58N0GB/02 (693 kb)
Range Hoods - D72F58N0GB/03 (693 kb)
Range Hoods - D77F56N0GB/01 (693 kb)