Votes - 0, Average rating: 0 ( )

Manafacture: Bosch File size: 6.85 mb File name: Language of manual:

5. Insert the activated carbon filter at the rear, fold up and lock in the middle with the wing nut. If the spacer rail has been removed, it must be re-installed. Activated carbon filter 6. Re-insert the two filter cartridges. Removing the activated carbon filter: q The activated carbon filter is removed in reverse sequence. Changing the activated carbon filter: If used normally (1 to 2 hours daily), the activated carbon filter should be changed approx. once a year. Activated carbon filters can be purchased from SPECIALIST OUTLETS (see optional accessories on the last page). Use original filters only. This will ensure optimum performance. Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants. They can be disposed of e.g. as residual waste. 38 Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. q At the same time as you renew the grease filter (see Filters and maintenance), clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. q Clean the extractor hood with a hot detergent solution or a mild window cleaning agent. q If the hood is extremely dirty (older stains), use a liquid window cleaner. q Do not scratch off dried-on dirt, but wipe off with a damp cloth. q Do not use scouring agents. Warning: Clean the control buttons with a mild detergent solution and a soft, damp cloth only. Painted, aluminium and plastic surfaces: q Do not use scouring agents or abrasive sponges. q Do not use dry cloths. q Do not use corrosive, acidic or alkaline cleaning agents. q Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. q Caution! Ensure that the kitchen is adequately ventilated. Avoid naked flames. Cleaning and care Changing the bulbs 1. Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. 2. Remove the filter frame. q See grease filter. 3. Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder). 4. Attach the filter frame. q See grease filter. Halogen bulbs: 1. Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns. 2. Remove the bulb ring with a screwdriver or similar tool. 3. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. 20 Watt, G4 cap). Caution: Refer to for plug-in lampholder. Take hold of the bulb with a clean cloth. 4. Re-insert the bulb ring. 5. Plug the appliance into the mains or switch it on at the fuse box. Note: If the light does not function, check that the bulbs have been inserted correctly. Installation Instructi...

Download now

Please, enter two numbers from picture: