Votes - 2, Average rating: 4.5 ( )

Manafacture: GE Monogram File size: 367.84 kb File name: Language of manual:

The Monogram beverage center and wine chiller can be used freestanding or as a built-in. Dimensions & Clearances Front ventilation allows the beverage center or wine chillder to be installed as a built-in and still operate efficiently. The bottom front grille area must remain unobstructed for proper air circulation and operation. Cutout dimensions shown allow for a full door swing and access to the pull-out racks. Locate Outlet 34-1/2"-35" 24" Min. 24" Min. 5" 34-1/2" 24-1/8" 23-7/8" Installation Options Increase storage capacity by installing two Monogram beverage centers side by side or two Monogram wine chillers side by side. Or, install a Monogram beverage center next to a Monogram wine chiller for a complete refreshment center. A side by side installation requires a 48" wide opening. No trim kits required. • The glass door fronts should align evenly with adjacent cabinet door fronts. Frameless Cabinets: • If installing between frameless cabinets, a 1/2" wide filler strip or side panel may be required. The filler strip will act as a spacer between the door case and adjacent cabinet and will prevent interference with cabinet door swing. The width of the opening must include filler panels. Provide two separate properly grounded electrical outlets for a side by side installation. Each electrical outlet should have a voltage rating that matches the rating plate. Grounding the Beverage Center or Wine Chiller IMPORTANT - (Please read carefully) FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance. Installation Preparation Beverage Center & Wine Chiller Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD. Use of Adapter plug Because of potential hazards under certain conditions, we strongly recommend against use of an adapter plug. However, if you still elect to use an adapter, where local codes permit, a TEMPORARY CONNECTION, may be made to a properly grounded 2-prong wall outlet by use of a UL listed adapter available at most hardware stores. Align Large Prongs/Slots Ensure Proper Grounding and Firm Connection Exists Before Use The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power cord. Use of an adapter plug will increase the cutout depth required. CAUTION Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded. When disconnecting the power cord from the adapter, always hold the adapter in place with one hand and pulling the power cord with the other hand. If this is not done, the adapter ground terminal is very likely to br...

Download now

Please, enter two numbers from picture: