Votes - 0, Average rating: 0 ( )

Manafacture: Bosch File size: 469.13 kb File name: Language of manual:

The display lights up in color and the stored shower temperature appears in °C and P1. Now open the water tap within 2 minutes and Wellness Program 1 starts. Warm water will run from the shower for 2 minutes according to the temperature setting and then cold water will flow out for 30 seconds. Tip: The best effect is obtained if you run Wellness Program 1 twice in succession. Starting Wellness Program 2 Press on the Wellness Programm button 2. The display lights up in color and the stored shower temperature appears in °C and P2. Now open the water tap within 2 minutes and Wellness Program 2 starts. At first, warm water will run for 1 minute (water temperature depends on your setting) and then 30 °C warm water will be dispensed for 30 seconds. Tip: Wellness Program 2 should be used a number of times in succession and can be repeated as often as desired. Ending Wellness Program 1 or 2 Both programs will repeat until either the button 1 or 2 is pressed (depending on the program selected) or the water faucet is shut off for more than 2 minutes or the temperature setting is changed. The temperature which was set before the program was started will be re-activated. The programs can also be activated while the water is running. Changing the temperature in a Wellness Program The preset temperature for the warm phase is 39 °C. This can be altered within the range 30 °C to 42 °C. Use the rotary knob to set the desired temperature within the range 30 °C and 42 °C. Store this value by holding down button 1 for three seconds. The selected temperature is now stored in Wellness Program 1. The temperature in Wellness Program 2 can also be altered in exactly the same way. Store this by holding down button 2 for three seconds. Setting a temperature limitation/child protection You have the possibility of limiting the temperature to 42 °C. Switching on the “Symbol key” Press buttons 1 and 2 simultaneously. The “Symbol key” appears in the display and the temperature is limited to 42 °C. Switching off the “Symbol key” Press buttons 1 and 2 simultaneously. The “Symbol key” disappears in the display and the temperature is now freely selectable. Mixing in of cold water in the fitting requires unnecessary water and energy. You should therefore set the desired water temperature directly on the continuous-flow heater and then open the water tap. If “eco” lights up in the display it means that the appliance is being run economically. The performance indicator shows the currently used performance of the continuous-flow heater in 10 % increments. An example: 7 increments are shown while drawing off hot water. This means that the continuous-flow heater is currently only running at 70 % of its maximum output. If the set temperature cannot be reached because the water throughput is too high, the continuous-flow heater will automatically adjust the water throughput until the set temperature is achieved. The continuous-flow heater can be operated with pre-warmed water (for e...

Download now

Please, enter two numbers from picture: