Votes - 0, Average rating: 0
(
)
)
|
manual abstract
The following window will appear on the display.
s Firmware Installation
Procedures
Install the firmware according to the following procedures.
q Firmware Uploader Installation
1. After the PC is powered up, the Windows start screen
will be displayed.
2. Insert the supplied disc into the computer CD-ROM
Drive. Here this disc drive is called the d: drive (for
3. Set bits #7 and #9 of the MODE selector to ON position
example).
(leave the others on OFF), and then press the [RESET]
button on the front of the WJ-NT104.
3. Double-click the My Computer icon on the desktop,
and then double-click the D: icon in the window.
4. Enter the KEY CODE into the boxes by pressing the
keyboard, then click the START button.
4. Double-click the SETUP.EXE. icon on the supplied
After the key code and unit status have been verified,
disc to start the setup procedure. Then follow the on-
the following window will appear.
screen directions.
Note: The software is normally installed in "C:\Program
Files" and “WJ-NT104 Utilities” is added to the pro-
grams in the taskbar.
q Firmware Installation
Caution: After updating the WJ-NT104 firmware, the
5. Set bits #7, #8 and #9 of the MODE selector to ON
system needs to be initialized. As this will restore
position (leave the others on OFF), and then press the
setup data and customized html files to the factory
[RESET] button on the front of the WJ-NT104.
defaults, it is recommended that you back up this
From the slit above the [RESET] button, confirm that
data in advance.
two green LEDs are lit.
• Backup your network data and customized html
6. Specify the file path for the firmware.
files, if applicable.
Select the program on the CD-ROM (d: drive).
At the MS-DOS level, enter "ftp>get netsetup.dat",
The factory default setting is A drive.
then "ftp>mget *.html" to store your data.
7. Click the RUN button in the window, then follow the on-
Install the firmware on the WJ-NT104 according to the
screen directions until the program has been loaded.
following procedure.
• It takes about 5 minutes to load the program.
1. Power up the Network Interface Unit. Confirm that the
• The two LEDs start to blink rapidly. After 5 minutes,
OPERATE indicator on the unit is on.
the LEDs will blink at a slower rate one after anoth-
er starting from the left, and then the fourth LED
2. Click the Start button. In the Start menu, click
(red) from the left will light up.
Programs. Point to the WJ-NT104 Utilities menu and
click FirmUpload to activate the program.
8. Click [OK] in the window to finish.
Remove the disc from the d: drive.
9. After updating the WJ-NT104 firmware, the system
needs to be initialized.
Set bits #1 and #2 of the MODE selector to ON position
(leave the others on OFF), and then press the [RESET]
button on the front of the WJ-NT104.
• The two green LEDs blink alternately, and then will
change to steady light.
10. Return all switches on the MODE selector to OFF posi-
tion and then press the [RESET] button on the front of
the WJ-NT104.
This completes installation of the WJ-SNT104E
Upgrade Software.
3
...