Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Mounting
1. Install the corner adapter.
2. Place the corner adapter at mounting location and use it to mark screw hole locations.
3. Mark Ethernet cable hole location (optional).
4. Drill screw holes in the wall according to the holes of the mount and a hole for cables
(optional), and then insert expansion screws into the mounting holes.
5. Pull the cables through the center hole of the corner adapter. Leave enough slack so that the
cable can pass through the bracket. If you passed cables through the wall, seal the hole with
exterior grade caulking.
6. Attach the corner adapter to the corner by aligning the 4 screw holes of the corner adapter
with the expansion screws on the corner.
7. Secure the corner adapter to the corner with nuts and washers to tighten the four expansion
screws.
Note: For outdoor applications, please waterproof tape around the center hole for waterproofing.
water
8. Secure the wall mount to the corner adapter with 4 hex screws and spring washers.
Nuts and Washers
Note: When tightening the screws, it is better to compress the spring washer firmly and then
rotate it 180° to waterproof it without damaging the threads.
9. Install the dome to the mount. Please refer to Section 6 for camera installation details.
5
...