Votes - , Average rating:
(
)
)
Manafacture: Ace Hardware
File size: 76.46 kb
File name:
Language of manual:
The document is loading, please wait
 |
The document is loading, please wait
manual abstract
At dawn, the control will reset to the motion sensing mode and shut off. This light control automatically turns the light on when motion is detected. Specifications: Total Lighting Wattage.................Up to 150 Watts Maximum Range ...........................................Up to 60 ft. Time Delay...................................1, 5, or 10 minutes Replacement lamp........................T3, Up to 150 Watt Maximum halogen 120 VAC Caution: This product is to be used with a U.L. listed rain tight or wet location suitable outlet box. Depending on the installation, additional hardware may be required. From HouseConnect the fixture ground wire to the junction box ground wire. Figure 1 - Wiring at Junction Box Plate 4. Attach the junction box cover plate to the junction box. Use a weatherproof sealant to seal the plate to the junction box. 5. Adjust fixture. The lamp head should be at least 1 inch away from the sensor. The sensor must be mounted below the lamp housing for wall installations. Caution: Do not mount the sensor above or touching the lamp (keep 1 inch or more from the lamp). The sensor bottom must be facing down for best coverage and to avoid water damage and electrical shock. CAUTION: To Avoid Fire Or Burn Hazards: • Allow fixture to cool before touching. The bulb and the fixture operate at high temperatures. • Keep fixture at least 1" from combustible materials. Do not aim at objects closer than 3 ft. • Use only T3, 150 Watt (Maximum) tungsten halogen 120 VAC lamps. Note: For under-eave installation, rotate the sensor head 180° by bending the sensor towards the clamp bracket. Rotate the sensor bottom clockwise away from the bracket. © 2005 595-5753-05 Modelo 3108685 / 3209574 1. InstalacionNota:La instalacion de este control de luz debe ser hecha solo porpersonasconexperienciaencableadosdecasacon120voltios. Algunos codigos locales pueden exigir que la instalacion de este control de luz sea hecha por un electricista certificado. Cuidado:Apaguesiempre elcortacircuitoscuando instale el aparato. 1. Retire el aparato existente. 2. Instale la correa de montaje en la caja de empalmes. Durante el proceso del cableado, puede ser conveniente para usted colgar el aparato de la correa de montaje usando el gancho provisto. 3. Conecte el control de luz como se muestra en la Figura 1: •El alambre negro del detector con el alambre negro (CALIENTE) de la casa. •El alambre blanco del detector con el alambre blanco (NEUTRO) de la casa. Nota: Para instalarlo debajo de los aleros, gire la cabeza del detector Lampara detectora por 180° doblando el detector hacia el soporte del sujetador. Gire ® el fondo del detector hacia la derecha desde el soporte e instale el del movimiento protector de la luz como se demuestra. 2. Punteria El area de proteccion del detector se muestra en la Figura 2. El detector debe estar dirigido de tal forma que se deyecte el movimiento al frente o a traves del area protegida. El detector debe estar apuntando hacia afuera y en angu...
Other models in this manual:Security Systems - ACE 3209574 (76.46 kb)