Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 2   File size: 636 kb   Manafacture: Jeep  
Category: Cameras
@name

studs and secure using original hardware. See Fig. 10. 12. Connect wiring to CD player. 5 IF VECHICLE IS EQUIPPED WITH A FACTORY 10 DISC CD CHANGER, PROCEED TO STEP 16. 13. Align top holes in VCP mounting bracket (item 7 pg 2) with holes in vehicle. See Figure 11. 14. Insert (2) two well nuts (item 2 pg 2) into top holes and secure using (2) 10-32 x 1" screws (item 3 pg 2) and (2) two # 10 washers (item 4 pg 2). See Figure 11. 15. Secure bracket to vehicle using (4) four # 10 X 1/2" screws (item

downloaded: 1   File size: 636 kb   Manafacture: Jeep  
Category: Cameras
@name

Remove and retain (6) six screws which secure CD changer to bracket. See Figure 3. Lay CD changer in a safe place. Discard bracket. FIGURE 2 FIGURE 3 IF VECHICLE IS EQUIPPED WITH A FACTORY 10 DISC CD CHANGER, PROCEED TO STEP 6. 3 5. Locate the O.E.M. storage pocket mounted to the rear passenger side of vehicle. Remove and discard pocket by moving it upward and outward. See figure 4. FIGURE 4 6. Using a pin router, razor knife, or suitable tool, carefully trim plastic panel as shown to allow clea

downloaded: 2   File size: 636 kb   Manafacture: Jeep  
Category: Cameras
@name

Before beginning this installation, carefully read through the following instructions. Use extreme care when cutting headliner material. Check for wiring or other componentry above headliner material. Cut only where indicated. Materials/ Tools required for this installation: 1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter 3. 1/4” hex socket bit 4. Razor knife or similar 5. 10 mm deep socket 6. Pin router or similar 7. Audiovox VCP (AVP-7180 or equiv.) MATERIALS PROVIDED F





Category