Votes - 2, Average rating: 4
(
)
)
|
Photos and specs Sony DCR-HC27E |
Other manuals for this model:
manual abstract
3 Slide the POWER switch repeatedly to turn on the PLAY/EDIT lamp while pressing DISP/BATT INFO on your camcorder, and keep pressing down DISP/BATT INFO for about 5 seconds. 4 Touch the “.” displayed on the screen with the corner of the “Memory Stick” or the like. The position of the “.” changes. If you did not press the right spot, start from step 4 again. • You cannot calibrate the LCD screen if it is rotated. On handling the casing • If the casing is soiled, clean the camcorder body with a soft cloth lightly moistened with water, and then wipe the casing with a dry soft cloth. • Avoid the following to avoid damage to the finish. – Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent, insecticide and sunscreen. – Handling with above substances on your hands. – Leaving the casing in contact with rubber or vinyl objects for a long period of time. About care and storage of the lens • Wipe the surface of the lens clean with a soft cloth in the following instances: – When there are fingerprints on the lens surface. – In hot or humid locations – When the lens is exposed to salty air such as at the seaside. • Store in a well-ventilated location subject to little dirt or dust. • To prevent mold, periodically clean the lens as described above. It is recommended that you operate your camcorder about once a month to keep it in optimum state for a long time. Additional Information Continued , 67 Maintenance and precautions (Continued) On charging the pre-installed rechargeable battery Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the POWER switch is set to OFF(CHG). The pre- installed rechargeable battery is always charged while your camcorder is connected to the wall socket via the AC Adaptor or while the battery pack is attached. The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all without the AC Adaptor connected or the battery pack attached. Use your camcorder after charging the pre-installed rechargeable battery. However, even if the pre-installed rechargeable battery is not charged, the camcorder operation will not be affected as long as you are not recording the date. x Procedures Connect your camcorder to a wall socket using the supplied AC Adaptor, and leave it with the POWER switch set to OFF(CHG) for more than 24 hours. Specifications System Video recording system 2 rotary heads, Helical scanning system Audio recording system Rotary heads, PCM system Quantization: 12 bits (Fs 32 kHz, stereo 1, stereo 2), 16 bits (Fs 48 kHz, stereo) Video signal PAL color, CCIR standards Usable cassette Mini DV cassette with the mark printed Tape speed SP: Approx. 18.81 mm/s LP: Approx. 12.56 mm/s Recording/playback time SP: 60 min (using a DVM60 cassette) LP: 90 min (using a DVM60 cassette) Fast forward/rewind time Approx. 2 min 40 s (using a DVM60 cassette and rechargeable battery pack) Approx. 1 min 45 s (using a DVM60 cassette and AC Adaptor) Viewfinder Electric viewfinder (color) Image device 3.0 mm (1/6 type) CCD (Charge Coupled Device) Gross: Approx. 800 000 pixels Effective (movie): Approx. 400 000 pixels Lens Carl Zeiss Vario-Tessar 20 . (Optical), 800 . (Digital) Focal length f=2.3 ~ 46 mm (3/32 ~ 1 13/16 in.) When converted to a 35 mm still camera In CAMERA: 44 ~ 880 mm (1 3/4 ~ 34 1/32 in.) F1.8 ~ 3.1 Filter diameter: 25 mm (1 in.) Color temperature [AUTO], [ONE PUSH], [INDOOR] (3 200 K), [OUTDOOR] (5 800 K) Minimum illumination 5 lx (lux) (F 1.8) 0 lx (lux) (during NightShot plus function) Input/Output connectors Audio/Video output 10-pin connector Video signal: 1 Vp-p, 75 . (ohms), unbalanced Luminance signal: 1 Vp-p, 75 . (ohms), unbalanced Chrominance signal: 0.3 Vp-p, 75 . (ohms), unbalanced Audio signal: 327 mV (at load impedance 47 k. (kilohms)), Output impedance with less than 2.2 k. (kilohms) DV input/output (DCR-HC28E) i.LINK Interface (IEEE1394, 4-pin connector S100) DV output (DCR-HC27E) i.LINK Interface (IEEE1394, 4-pin connector S100) LCD screen Picture 6.2 cm (2.5 type) Total dot number 123 200 (560 . 220) General Power requirements DC 7.2 V (battery pack) DC 8.4 V (AC Adaptor) Average power consumption During camera recording using the viewfinder 1.8 W During camera recording using the LCD 2.1 W Operating temperature 0 °C to 40 °C (32 °F to 104 °F) Storage temperature -20 °C to + 60 °C (-4 °F to + 140 °F) Dimensions (approx.) 65 . 79 . 113 mm (2 5/8 . 3 1/8 . 4 1/2 in.) (w/h/d) (including the projecting parts) 65 . 79 . 113 mm (2 5/8 . 3 1/8 . 4 1/2 in.) (w/h/d) (including the projecting parts with supplied battery pack NP-FP30 attached) Mass (approx.) 360 g (12 oz) main unit only 420 g (14 oz) including the NP-FP30 rechargeable battery pack and DVM60 cassette. Supplied accessories See page 8. AC Adaptor AC-L25A/L25B Power requirements AC 100 - 240 V, 50/60 Hz Current consumption 0.35 - 0.18 A Power consumption 18 W Output voltage DC 8.4 V* Operating tem...
Other models in this manual:Cameras - DCR-HC28E (1.35 mb)