Votes - 4, Average rating: 4
(
)
)
|
manual abstract
1 hour PV-L560) {approx. 1 and 1/2 hours PV-L660). 3 Remove Battery Slide Battery out and off. • Battery life gradually decreases after repeated use and recharging. If operation time becomes very short even after a sufficient charge, discard Battery properly (page 11). Note: After recharging 5 times, use BATTERY REFRESH feature as explained on page 11 Using the Battery Pack A fully charged Battery provides a maximum of about 1 hour 10 minutes (PV-L560) or 2 hours (PV-L660) of continuous use (LCD monitor off) or about 55 minutes (PV-L560) or 1.5 hours (PV-L660) (LCD monitor on). Actual time may vary due to operating conditions. Using the Built-in Light decreases operating time. 1 Attach Battery Align Battery with top of mounting surface. © Press and snap into place. Remove Battery While sliding BATTERY RELEASE. remove Battery. 10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com Supplying Power Battery Refresh This feature completely discharges Battery before recharging begins. Use after about every 5 charges for optimum Battery performance. 3 BATTERY REFRESH (PV-L660 shown) Caution: • Charge only with specified charger. • Battery can be charged within a temperature range of 10 °C (50 °F) and 35 °C (95 °F). • Battery is normally warm after charging or just after use. • Do not use an insufficiently charged or worn-out Battery. Safety precautions: • Do not get Battery near, or dispose of in fire. • Do not directly connect (short circuit) the positive (+) and negative (-) terminals. • Never attempt to disassemble or reassemble Battery. 1 2 3 Plug in AC Adaptor. • POWER Lamp stays on as long as Adaptor is plugged in. Place Battery into Adaptor. Press BATTERY REFRESH. The CHARGE Lamp flashes during discharge then stays lit until charging is complete. If BATTERY REFRESH is pressed by mistake, remove Battery from Adaptor and reinsert it for normal charging. 4 Remove Battery. Charging takes about 5 hours (PV-L560) or 7 and 1/2 hours (PV-L660) when Battery Refresh is used. Battery will not operate in extremely high temperatures. To avoid Battery damage: • Do not drop or jar Battery. • Use Battery with specified units only. • If Battery is used in extremely high temperatures, a safety device will automatically prevent operation. To prolong Battery life: • While not in use, remove Battery from the Camcorder and AC Adaptor and store in a cool, dark, dry place. • Keep Battery terminals clean. U.S.A. CONSUMERS:-- ATTENTION: The product you have purchased is powered by a nickel cadmium battery which is recyclable. At the end of its useful life, under various state and local laws, it is illegal to dispose of this battery into your municipal waste stream. Please call 1-800-8-BATTERY for information on how to recycle this battery. 11 Supplying Power VCR DC OUT Connector Connect AC Adaptor VCR DC OUT to Camcorder DC IN with supplied DC Power Cable. Plug in AC Adaptor. POWER Lamp lights. Note: • AC Adaptor cannot power Camcorder while charging Battery. • When not in use, unplug AC Adaptor from AC outlet. (Adaptor uses 1.2 W of electricity while plugged in.) CAUTION: This unit will operate on 110/120/220/240 V AC. An AC plug adaptor may be required for voltages other than 120 V AC. Please contact either a local or foreign electrical parts distributor for assistance in selecting an alternate AC plug. We recommend using the accessory power plug adaptor (VJSS0070) in an area which has special AC outlets. Car Battery Cord (Optional) Car Battery Cord Cigarette (optional) Lighter Plug I Connect PV-C16 Car Battery Cord (optional) to Camcorder DC IN. 2 A Start engine first. B Plug Car Battery Cord into Cigarette lighter socket. • If Car Battery cord fuse needs replacing, use exact current rating (in amps). Note: • This cord only works in vehicles equipped with DC 12 V (negative ground) battery. Check with your car/truck dealer. Use only specified car battery cord. • To avoid blowing the car battery cord fuse, do step 2 in the proper order. • Running vehicles must be well ventilated. • When not in use, disconnect cigarette lighter plug. 12 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com Cassette Information 1 2 3 4 5 Turn Tape Wheel in direction of arrow until there is no slack. Attach Battery {page 10). Slide TAPE EJECT to open door. Insert cassette as shown. Press here to close door. Record/Playback Time Use tapes with the mark in this unit. • To remove the cassette, slide the TAPE EJECT switch. TAPE SPEED Selector Tape Speed Selector Position Cassette type TC-20 TC-30 TC-40 SP (Standard Play) 20 minutes 30 minutes 40 minutes SLP (Super Long Play) 1 hour 1 hour 30 minutes 2 hours SLP playback may contain more picture noise. Erase Protection Tab A record tab ensures recordings are not accidentally erased. 1 2 To prevent eras...