63 Before beginning installation • In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric connection to the mains is available and if it is possible to connect a fumes discharge device to the outside (Extraction mode only). • Warning! Do not connect the appliance to the mains until the installation is fully complete. • Install the electronic box with 2 screws (a-b-c). Fig. 6 Fig. 6a Fig. 6b Fig. 6c Installation • Remove t

The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit’s front panel: Light switch Speed 3 Speed 2 Motor switch Speed 1 • the light switch switches the hood lamp on and off • the motor switch switches the motor off • Speed 1: Speed 1 push-button • Speed 2: Speed 2 push-button • Speed 3: Speed 3 push-button Maintenance and Care Warning! Before performing any maintenance operation, isolate the hood from t

Repeat the process if necessary. Refit the grease filters when it are dry. Dishwasher machine • Place grease filters in dish washer. Select most powerful washing programme and highest temperatu- Fig. 3 re, at least 65°C. Repeat the process. Refit the grease filters when it are dry. When washing the metal grease filter in the dishwasher a slight discoloration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hot detergent solution only (n

01 80/5 30 40 50 (E 0,14/Min. DTAG) en page 3–16 es pagina 31 – 44 fr pages 17 – 30 Fig. 1 GAZ ELECTRO Instructions for use: Appliance description Filter grille Chimney panelling Light / fan switches Lighting Operating modes Exhaust-air mode: . The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. . The grease filter absorbs the solid particles in the kitchen vapours. . The kitchen is kept almost free of grease and odours. WARNING Wh

3. In buildings with excessively high water pressure, a condition known as “water hammer” may exist. This condition is caused by a combination of high water pressure and the abrupt closing of a faucet valve or internal washer/toilet valve. This instant change in flow results in an instant change in the internal pressures in the pipe, which then sends a shock wave through the pipe. This physical shock will shake, rattle or cause a loud bang in the plumbing which is referred to as “water hammer.”

1.4 Requirements for installation in Massachusetts Attention residents of the Commonwealth of Massachusetts: In the Commonwealth of Massachusetts the following regulation went into effect on 12/30/2005: (a) For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residential purposes, including those owned or operated by the Commonwealth and where the side wall exhaust vent termination is less than seven (7) feet a

(Fig. 6) 2. Lay copper capillary sensing tube across top of the draft diverter. Allow excess tube to hang down right side of heater. Do not cut or crimp capillary tube. 3. Route the two wires from the spillage switch down the left side of heater to the ECO keeping the cables out of contact with hot surfaces. (Fig. 6) Connecting linear safety spillage switch to pilot safety circuit The ECO/temperature limiter is mounted on the lower left outlet water pipe. (Fig. 7) 1. Remove one wire lead connect

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information consult a qualified installer, service agency or the gas supplier. In the Commonwealth of Massachusetts this product must be installed by a licensed plumber or gas fitter. Upon completion of the installation, these instructions should be handed to the user of the appliance for future reference. * The GWH 425 HN has been redesign