Votes - 1, Average rating: 4
(
)
)
|
manual abstract
• The minimum safety distance between the cooker top and the extractor hood is 650 mm. • Check that the mains voltage corresponds to that indicated on the rating plate fi xed to the inside of the hood. • For Class I appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to the exhaust fl ue through a pipe of minimum diameter 120 mm. The route of the fl ue must be as short as possible. • Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fi replaces, etc.). • If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a suffi cient degree of aeration must be guaranteed in the room in order to prevent the backfl ow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE • The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. • Never use the hood for purposes other than for which it has ben designed. • Never leave high naked fl ames under the hood when it is in operation. • Adjust the fl ame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. • Deep fat fryers must be continuously monitored during use: overheated oil can burst into fl ames. • The hood should not be used by children or persons not instructed in its correct use. MAINTENANCE • Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. • Clean and/or replace the Filters after the specifi ed time period. • Clean the hood using a damp cloth and a neutral liquid detergent. GB 13 CHARACTERISTICS Dimensions Components Ref. Q.ty Product Components 1 1 Hood Body, complete with: Controls, Light, Blower, Filters 9 1 Reducer Flange o 150-120 mm Ref. Q.ty Installation Components 12c 2 Screws 2,9 x 6,5 Q.ty Documentation 1 Instruction Manual 1 Electric Diagram Hood Type 54 72 L 540 720 L1 512 692 GB 14 INSTALLATION Drilling the Support surface and Fitting the Hood The Hood can be fi tted directly to the underside of the Wall units (min. 650 mm above the cooker top) with snap-on side supports, which are set up for a support panel thickness of between 15 mm and 30 mm. • Cut a fi tted opening in the bottom surface of the wall unit, as shown. • Remove the metal grease fi lters (see par. on Maintenance). • Disconnect the fi lter support by turning the internal handles provided. • Insert the hood until the side supports snap into place. • Lock in position by tightening the screws Vf from underneath the hood. Hood Type 54 72 L2 515 695 GB 15 • Replace the fi lter support • Screw the fi lter support using the 2 screws 12c (2,9 x 6 ,5) provided. • Replace the grease fi lters make sure that the handle is visible on the outside. Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a fl exib...
Other models in this manual:Fans - L1 400370 (1.25 mb)
Fans - L1 512 692 (1.25 mb)
Fans - L2 515 695 (1.25 mb)