Votes - 3, Average rating: 4.3 ( )

Manafacture: Electrolux File size: 413.43 kb File name: 1d4de783-9a79-4b11-a5a0-a07837c1a8d8.pdf Language of manual:

Select the height position within 10 seconds. 1. Press m. The downdraught extractor will move to top position and switch on at extraction rate 1. The dampers will deploy on the way up. Safety If the downdraught extractor is obstructed on the way up, it will switch off automatically. Lowering 1. Press l. Extraction will be turned off. The downdraught extractor will stop when you release the button. Pressing k will turn extraction off, but the downdraught extractor will remain where it is and not descend into the worktop. Extraction rates The downdraught extractor can be set to three levels and intensive extraction. Level 1: 150 m./h Level 2: 220 m./h Level 3: 345 m./h Intensive extraction: 480 m./h Setting the extraction rate When the downdraught extractor is on, raised and at rate 1. 1. Press < one press = level 2 two presses = level 3 Adjusting the extraction rate The extraction rate can be adjusted by pressing <. Switching extraction off Press < until the display shows 0. 13 Intensive extraction The downdraught extractor is on and raised. 1. Press b. The downdraught extractor will extract on intensive for 5 minutes. It will then return automatically to its last setting before intensive extraction was activated. If extraction was off before intensive extraction was activated, extraction will be turned off automatically after 5 minutes. Switching off intensive extraction You can switch intensive extraction off before the 5 minutes are up. Press b. 14 Time-controlled switching off You can set the downdraught extractor to switch off automatically at a later time. Time-controlled switching off can be set from 1 to 99 minutes. When the downdraught extractor is switched on and raised up. The suction strength is switched to speed 1, 2 or 3 (not to intensive suction). 1. Press the A button. By pressing once at a time, you set one minute at a time. If you hold the button down, you set 5 minutes at a time. If you pass 99 minutes, the time will display “00”. You must then let the button go and press the button again to make a new setting. You can read off the time set in the display. The time counts down one minute at a time. When there is one minute left, the time counts down one second at a time. 15 When the time set has passed, suction strength is switched off. The downdraught extractor remains in the height position set. If you want to switch off the extraction rate before the time has passed, press the A button until the display shows “00”. Autostop If the downdraught extractor is left on by mistake, Autostop will turn extraction off automatically after 6 hours. The downdraught extractor will remain at the height position to which it was set. When Autostop has been active, the control lamp for k flashes. Press k to reset Autostop. 16 Correct ventilation The extractor works best when there is low pressure in the kitchen. Therefore, the kitchen windows must be closed when the extractor is in operation. At the same time, it is a good idea to open a window in an adjacent room; see fig. Always start the extractor a few minutes before you start preparing food. Always continue to ventilate after you finish preparing food. Use intensive extraction with automatic stop or time-controlled switching off after 15 minutes. 17 Cleaning and maintenance The product should be kept clean for reasons of hygiene and safety. Never use metal cleaning pads, metal sponges, hard plastic sponges, scouring powder, soft soap or other abrasive and caustic cleaners. Aluminium Carry out daily cleaning with a well wrung-out cloth. For more stubborn soiling, use a cloth or a soft plastic sponge together with washing-up liquid or all-purpose cleaner. Never use metal cleaning pads, metal wool, hard plastic sponges, scouring powder, soft soap or other abrasive or caustic cleaning agents. Ceramic hob After use, wipe the extractor with a damp cloth and washing-up liquid. If necessary, finish off with a clean, dry cloth. Top cabinet The top cabinet may become spattered with fat from frying. To clean 1. Switch the extractor on and raise it to the top position. 2. Lift the top cabinet off. 3. Wipe the top cabinet with a damp cloth and washing-up liquid or universal cleaner. Filter After 30 hours of use the timer display will indicate that the filter needs cleaning. "CL" will appear on the display. 1. Switch the extractor on and raise it to top position. 2. Lift the top cabinet off. 3. Turn the top cabinet upside down and put it on a soft base. Take care not to scratch the glass on the top. 4. Remove the spring securing the filter by pressing on its sides. 5. Lift the ...

Download now

Please, enter two numbers from picture: