Votes - , Average rating:
(
)
)
Manafacture: Vitek
File size: 198.8 kb
File name: Vitek-VT-1914-Pdf-Rus.Pdf
Language of manual:
The document is loading, please wait
 |
The document is loading, please wait
manual abstract
Следите, чтобы выступы на корпусе мотора совпали с отверстиями на решетке. Закрепите решетку винтом (7). 3. Установите лопасти (8) на ось до упора и закрутите их, повернув против лопастей/отключение и задней решеток СБОРКА 6 ENGLISH DESCRIPTION OF PARTS 7. Connecting nut for the rear grill 1. Base 8. Wheel with the blades 2. Oscillator shaft 9. Connecting nut for the wheel with 3. Motor the blade 4. Switch 0-1-2-3 10. Front grill 5. Swivel knob 11. Clamps 6. Rear grill 12. Grill Nut INSTRUCTIONS FOR SAFE USE: 1. Before you put the plug in the socket, please check if the voltage mentioned on the oscillator matches the voltage of your electricity. 2. Never stick your fingers, pencils or other objects through the grill of the oscillator when it is turned on. 3. Unplug the oscillator when you move it somewhere else. 4. Unplug the oscillator when you remove the grill to clean it. 5. Check if the oscillator is put in a sturdy place to prevent it from falling over. 6. Do not expose the oscillator to rain, jets of water or moisture. 7. Finally, before each use, check if the power supply cable is damaged. 8. If the lead is damaged, it should be replaced by an expert. ASSEMBLY: 1. Remove the serration nut at the end of the oscillator shaft. 2. Place the oscillator shaft in the whole of the base. 3. Screw in the serration nut and tighten it well. 4. Unscrew the serration nut on the axle of the oscillator by turning it clockwise. 5. Unscrew the connection screw of the rear grill by turning it counterclockwise. 6. Place the rear grill in front of the motor in the intended spaces. 7. Attach the grill with the help of the serration nut. 8. Place the wheel with the blades on the axle of the motor. 9. Attach this one with the cap nut by turning it counter clockwise. 10. Attach the front grill to the rear grill by means of the clamps and the safety screw. 3 Vt-1914.qxd 03.12.03 14:53 Page 8 О ENGLISH РУССКИМ USE OF THE OSCILLATOR: The oscillator is fitted with a switch having 4 positions, namely positions 0-12-3 with the following functions: СХЕМА ВЕНТИЛЯТОРА 0: Stop 1: Low speed 2: Medium speed 3: High speed SWIVEL: The oscillator is fitted with a knob next to the switch with which you can swivel the oscillator. Push in the knob to let the oscillator swivel. Pull the knob out when you want to stop the swiveling. Place tilted: You can tilt the oscillator in several directions: a serration with a spring keeps the oscillator in the desired position. CLEANING: 1. Unplug the oscillator before you clean it. 2. Do not use abrasive agents or acid. 3. Clean the oscillator with a cotton cloth. SPECIFICATION Power requirement Max. power Blade-diameter 3 speed setting 220-230 V ~ 50 Hz 25 W 12” (30 cm.) SERVICE LIFE OF THE FAN NOT LESS THAN 5 YEARS o- 4 5...