Votes - 4, Average rating: 3.5 ( )

Manafacture: Faber File size: 152.63 kb File name: Language of manual:

With a black or white glass front that pairs well with ceran cooktops, the Agio tilts in, flush with your cabinets, neatly tucking the hood away. For total integration, the glass front can be replaced with material to match your cabinets, hiding the hood completely. A patented front panel hinge system allows the rangehood to tilt out when in use and then tilt back in flush with your cabinets to allow easy access to the cabinets above. The direct rear venting option frees up all the cabinet space above. When converted to ductless, takes up no space in the cabinet The glass front can be replaced with a standard drawer front or a custom piece to integrate the Agio into the cabinetry. p.o. box 435 • Wayland, MA 01778 • tel: (508) 358-5353 • fax: (508) 358-5730 • e-mail: info@faberonline.com • Dimensional Diagram Custom Front Panel Dimensions - for replacing the entire front panel* 23 5/8” or 29 15/16” or 35 15/16” 5 7/8” * If you wish to keep the frame of the front panel and only replace the glass panel, the dimensions are as follows: A=5 11/16", B=1/8", C= 23 6/16" (for 24" model) or 29 11/16" (for 30" model) or 35 11/16" (for 36" model). The glass panel is 1/8" thick, but the frame is adjustable to accommodate a thinner panel like stainless steel. Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing this rangehood. The recommended height to install this hood off the cooktop is a minimum of 24" and a maximum of 30" for maximum effectiveness. Also consult the cooktop manufacturer's recommendation. Pre-Planning Your Ductwork - Important: Consult the installation instructions before you begin installing this rangehood. Make your ductrun as straight and short as possible. The ductrun should not exceed 25 equivalent feet if ducted with 3 1/4" by 10" rectangular duct. Count 45° angles as 3 feet, 90° elbows as 5 feet, and 90° flat elbows as 12 feet. For best results, use no more than three 90° elbows. Make sure that there is a minimum of 24" of straight duct between elbows if more than one is used. Do not install two elbows together. If you must elbow right away, do it as far away from the hood's exhaust opening as possible. Ductless Installations For installations where ductwork is impossible or highly impractical Charcoal Filters, which attach to the blower assembly, absorb smoke and odors. The blower must be positioned with the exhaust pointing forward (...

Download now

Please, enter two numbers from picture: