Manafacture: Broan
File size: 2.31 mb
File name:
|
manual abstract
Charcoal filter LED (C) The charcoal filter LED C CCCCC will start to flash when the charcoal filter needs to be replaced. This operation is necessary after approximately 160 working hours. Resetting the saturation indicator After cleaning or replacing the filters, press button 3 33333 for 3 seconds until the grease filter LED F FFFFF or the charcoal filter LED C CCCCC stops flashing. 14 electrolux maintenance and care Maintenance and Care • Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Air suction panels EFC 9673 only Remove the perimeter air suction panels to access the grease filters. The perimeter air suction panels are attached to the cooker hood by a series of pins and coupling springs; pull them outwards and detach them from the fastening cable. Clean the perimeter air suction panels as often as the grease filters (for more information about gentle cleaning methods, read the paragraph “Cleaning” in the pages that follow). When refitting the perimeter air suction panels, ALWAYS reattach the fastening cables. Make sure the panels are attached to the cooker hood properly (snapfastened). Metal gr Metal grMetal grMetal grMetal grMetal grease filter ease filterease filterease filterease filterease filter • The purpose of the grease filters is to absorb grease particles which form during cooking and it must mustmustmustmust must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Removing the metal gr Removing the metal grRemoving the metal grRemoving the metal grRemoving the metal grRemoving the metal grease filter ease filterease filterease filterease filterease filter • Use the spring handle and remove the filter downward. Hand washing Hand washingHand washingHand washingHand washingHand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher DishwasherDishwasherDishwasherDishwasherDishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. electrolux electroluxelectroluxelectroluxelectroluxelectrolux maintenance and care 15 1515151515 • Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). 16 electrolux maintenance and care Charcoal filter • The charcoal filter should only be used if you want to use the hood in recirculation mode. • To do this you will need an original charcoal filter (available from your local Service Force Centre). • Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. With normal use the filter should be cleaned every second month (when using the hood 2.5 hours per day,on avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the charcoal, the filter should be dried in an oven for 10 minutes with a maximum temperature of 100. C. After approximately three years of use, the charcoal filter should be replaced with a new one, as the odour reduction capacity will be reduced. • Fitting Position the carbon filter inside the hood to cover the protection grill of the motor. Fix the filter with 2 lateral knobs. • To remove proceed in the reverse order. • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. • The charcoal filter can be ordered from your local Service Force Centre. electrolux electroluxelectroluxelectroluxelectroluxelectrolux maintenance and care 17 1717171717 W WWWWWar arararararning ningningningningning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb(s) Changing the light bulb(s)Changing the light bulb(s)Changing the light bulb(s)Changing the light bulb(s)Changing the light bu...
Other models in this manual:Fans - U31180 EFC 9673 (2.31 mb)