|
manual abstract
GB b) Take the decorative flue and rest it on the hood. Lift the upper flue up to the ceilingand secure it using the 2 screws (L). c) Lift the lower flue holding it firm with some adhesive tape and connect the flexible hose to the reducer (E) with a hose clamp (not provided). 3 Technical information GB Electrical connection ! Arrange the electrical power supply within the decorative flue dimensions. ! When making the electrical connections, check that the voltage values correspond to those indicated on the data plate inside the appliance itself. ! In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensu-ring omnipolar disconnection from the elec-tricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. ! If your unit features a power lead and plug, position this so the plug is accessible. ! The following warning is valid in the United Kingdom only (in case your cable is not furnished with a plug). As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: – the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black; – the wire which is coloured brown must be connected to the terminal which is marked with the Technical data letter L or coloured red. For hoods in insulation class 1 (mod.HS63X): – terminal of a three-pin plug. For hoods in insulation class 1 (Mod. HS73XHS93X- HSD93I): – the wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol [ ], or coloured green or green and yellow. Power cable ! Warning: The hood is fitted with a specially prepared cable (except for the hood model HS63X); if the cable is damaged, it must be replaced with a cable or special cable assembly, available at the manufacturer or its technical service. Model HS 63 X HS 73 X HS 93 X / HSD 93 I Dimensions width 59.8 cm height 68/119 cm depth 49 cm Outlet pipe diameter 15 cm width 69.8 cm height 68/119 cm depth 49 cm Outlet pipe diameter 15 cm width 89.8 cm height 68/119cm depth 49 cm Outlet pipe diameter 15 cm Gross weight 14.6 Kg 15.6 Kg 19.1 Kg Absorption Total 220 W Motor 1x140 W Lamps 2x40 W Total 260 W Motor 1x180 W Lamps 2x40 W Total 260 W Motor 1x180 W Lamps 2x40 W Flow rate 450 m3/h 600 m3/h 600 m3/h Grease filters Suction surface area 1487 cm2 1773 cm2 2287 cm2 4 Description The hood may be in the filtering or ducting version. Decide from the outset which type is to be installed. For better efficiency, we recommend installing the hood in the ducting version (if possible). Filtering version The hood aspirates air from the kitchen impregnated with fumes and smells, purifies it through the grease filters and the charcoal filter, and then circulates clean air back into the room. This version requires an air baffle (M) and a charcoal filter (P). In order to maint...
Other models in this manual:Fans - HS63X (1.15 mb)
Fans - HS93I (1.15 mb)
Fans - HS93X (1.15 mb)